rhinocables Finger Plate Surround for Single Light Switch faceplate or Electrical Plug Socket White Plastic (1)

Looks good and easy to fit

A bit pricey for what they are but they are doing the job.

Item arrived promptly and does exactly what it’s meant to do, giving the switches a clean, modern finish. After isolating the circuit at the main fuse box, I was able to fit the surrounds without disconnecting any cables by simply loosening the screws. The key is to place the surround on at a diamond angle, tilt the switch slightly, get two corners through, then straighten it to ease in the third and fourth corners. The photos included show this clearly and should help others fit them with minimal effort. One important safety note: even after isolating the downstairs circuit, one switch was still live as it was linked to the upstairs circuit, so using a voltage tester before starting is strongly recommended. Overall, good value for a six-pack and a tidy upgrade. Hope this helps.

Look great you do have to take the socket off to put them in but as long as you know what your doing it’s easy .

They did the job but honestly aren't quite as good as I hoped for. They just have that cheap plastic look and feel which I guess is under you get what you pay for, I haven't tried to paint them but I'm sure you could, you would just need to sand and prime them first

Very good 👍

The plastic is VERY shiny so require sanding with a fine paper before painting if you need to match them to the existing paintwork. After doing this the paint bonded well. Also worth noting they do not fit directly around the outside of the switch - you will need to completely disconnect the switch and put the wiring through the plate before reconnecting. Personally I'm OK with this but not everyone will be. In the end they worked well and looked good.

absolutely happy with product, snugs behing the socket without the need of any adhesive.

It doesn’t look great; too white. take care to get the right colour match