Ensayeer Power Wheel Adapter with Fuse & Switch, 12V M12 Lithium Battery Connector, 12 Gauge Wire, DIY Ride On Truck, Robotics, RC Toys & Work Lights, Black, 12V Input & Output

Great for the price

Fantastic. I work in a boatyard as an electrician on mostly 12v Systems. This comes in quite handy when testing pumps, lights, and other various systems. The clips meant to hold the battery in are a bit tight and don't seat fully but I've yet to have a battery fall out. Overall still 5 stars

This adapter is perfect for my project, and I like that it comes with an attachment mount that I was able to trim and run a zip tie around it, along with a few layers of VHB tape for mounting. The wires seem to be high quality 12 AWG, nice and safe. This fit my Milwaukee 12v 1.5 and 2.0 Ah batteries just fine, but for my xc 4.0 battery to clip in, I had to shave it down a little. My 3.0 Ah compact battery is the one I need to use the most, and it will not clip in at all, it seems like the battery is about 1.5 mm longer after the clip than the 2.0 battery. I'm going to try expanding the clip hole on this adapter a little bit, so my 3.0 battery will stay clipped in. Well worth it, and I specifically got this because it's black

Used for a fuel pump on my engine test stand. Worked good

- Doesn't fit and lock battery (tryed it with original and chinese knock off battery too)- the wallmount doesnt lock on the adaper so every time U try to change battery it will fall of of the mount- the switch is shrinked on the wire so tight U have to cut it off if you want to install it through a hole (as this type of switch needs to be installed)Overall a POS but U can make it work with a dremel tool some JB weld and and some extra wiring...LMAO