KREG® Precision Miter Gauge System

Arrived promptly but with 2 minor bits missing. New parts arrived in a couple of days following a phone call. Very accurate. It has taken my use of the saw bench up a level in accuracy.

A bit expensive for this. Used few times but you can build a sled for better cuts.

Recht teuer aber definitiv sehr gut, sehr präzise für holzarbeiten

Muy preciso y también brinda seguridad al realizar el trabajo.

j'acheté cette jauge pour ma scie sur table évolution rage 5, satisfait de cet achat,après une modification de la barre alu guide qui a une épaisseur de 9,5mm à 7mm car la profondeur de la rainure de table n'a que 7mm,je pouvais le fraiser au boulot.la largeur de ce guide est de 18,6 et la largeur de la rainure de table est de 19,6,dans la largeur de ce guide y'a 5 taraudages M5,des vis M5 sans tête sont avec pour règler le jeu,autre bémol le mètre ruban adhésif est en inch,j'en ais acheté un métrique sur amazone

This was a hard decision, buy Incra or Kreg. I read every available review and the precision miter comparison review in the Fine Woodworking Magazine where the Kreg was judged to be the best buy. Incra miter has a lot of features but it appears that the attachment bracket on this product needs to be shimmed, a no, no to leave that to the buyer. The Kreg is advertised as factory calibrated and I can confirm it actually is. I recommend to set the Kreg miter up very carefully. I used Lee Valley set up blocks instead of a tape measure. Use utmost care in cutting the tape correctly. The miter bar guide screws where set up as follows: ( deviation from manual) - insert all plastic guide screws with a correct fitting screw driver - use a stop block to set all 5 screws flush with bar - then turn each screw exactly the same amount in small increments if bar is sloppy (think carburetor adjustment) This procedure works best and I was able to set guide over entire lengths first time with a sweat alignment as result. Following the Kreg procedure is a hit or miss. Next, the unit should definitively used with a 3/4" fence long enough to extend over saw blade. This way you have proper backing for small work pieces. I made several for straight and miter cuts. However I screwed the first on up as I did not allow for the plastic guides inserted in the extrusion. I recommend to measure centreline for holes with miter installed. Other Option would be if Kreg would add these dimensions to the manual to avoid these mishaps. This miter gauge is definitively a buy. I will make my own stop attachment for mitred pieces the Kreg option is no good.

The Kreg KMS7102 Precision Miter Gauge System is a top-tier upgrade for any table saw user looking for repeatable, highly accurate cuts. Right out of the box, it's factory-calibrated and requires minimal setup. The precision is spot on—it locks in angles securely and doesn’t drift during the cut, which is a major improvement over the wobbly, basic miter gauges that come with most saws. The fence and stop system are extremely helpful for making consistent crosscuts and angled cuts. The anodized aluminum fence is long, sturdy, and easy to adjust, while the adjustable bar fits snugly in the miter slot with zero play, eliminating inaccuracies caused by wiggle or flex. The angle markings are clear and precise, and the positive stops at common angles (like 0°, 22.5°, 45°) make setup fast and frustration-free. Whether you're working on fine woodworking or just want dead-on cuts in DIY projects, this gauge delivers. If you want to upgrade your table saw for greater accuracy, repeatability, and ease of use, the Kreg KMS7102 is worth every penny. It’s a reliable, professional-quality tool that makes a noticeable difference.