Stand for Google Pixel Watch by IRONA, Silicone Charging Dock Holder Compatible with Google Pixel Watch Charger, Easily place(Supports Nightstand Mode) (Adapters NOT Included), Black

Easy to set up and use. My watch was constantly falling off my unit so I needed something, so glad I found this 😁

Charger Stand for Google Pixel Watch. Not very good. Not worth the ten pounds they want for it either.9.99 at time of review. 2*.

This stand is a holder for my existing charger, it doesn't come with its own charger - but this is clear from the listing description which is good. It's a fairly dense lump of silicone type material, strong but squishy. It flexes easily enough to allow the USBC cable to be fed through from the front, and down to the base, and out the back. It is heavy enough, and non slip enough, to not skid around on my desk which was the main issue I have with the original charging puck on its own. However, it's not 100% compatible with all the straps, if you check my photos, the fabric loop strap that I use for comfort, whilst being slightly unusual I imagine, has a loop feed that wants to flow perpendicular to the mounting points on the watch. This pulls the watch to one side, it still chargers, but not at full speed, I'd estimate at about 60% speed. This could be solved by tapering the silicone around the puck so that it falls-away at an angle more. I'll take a knife to mine and adjust it. I'm sure it works fine with the stock strap, but keep in mind that you mind need to tweak it for best results with the alternative bands.

Handy stand for my desktop.A little fiddly, to start with. Had to use a couple of strips of thin card to lift the watch slightly to make best contact while charging.

These are ok. They are a tad on the heavier side so as not to move and topple over when watch is charging.My only gripe which wasy own fault. Is that you have to insert your own charging base into this holder.

Excellent design bought for son who loves it

not that it does not include the charger

Since I've received my watch last year, I found the charging pebble to be a bit of a pain. So I ordered this and am pleasantly pleased.I'm using the standard strap that came with the watch. Note that there are other people here who have commented about some issues with non-standard watch straps.It's basically a moulded piece of rubber, that has some weight to it, where you can pass your cable through and hold both the cable & charging pebble in place. You then rest your watch on it's side, which is more natural position compared to stretching out the strap in an attempt to lie it flat like the default charging position expects you to.As I don't need to contort the device and I just place it on the stand, the magnet pulls in the watch immediately and doesn't slip off like I'm used to.I like that as it's all rubber and the cable is held in place by the grooves in the stand, it stays where you put it.So as a non-intrusive device, it works great for me personally. I can recommend.