5-Piece Precision Dispenser Set – 10ml Fine-Tip Bottles for Crafting, Lubrication, and Detailed Adhesive Work (Leak-Proof Multi-Use Design)

Second time of ordering; I dispense craft glue from large bottles into them for use on papercraft projects. Previously, the bottles were opaque - could be seen through if held up to the light. These ones are clearer bottles, which makes it much easier to check the glue level. The fine point is really helpful as larger bottles often dispense too much glue at a time, which can be messy. These are easy to fill by removing the whole cap and work well, dispensing just the right amount of glue, even on very fiddly pieces. Just remember always to put the plastic cover back on the tip after every use and they rarely block; if they do, a safety pin usually does the trick - or, for my glue, as a last resort, remove the cap and run it under warm water.

Perfect for glue etc

Arrived ok and some used within minutes does the job.

Perfect for using with enamel paints to pinline 3d prints, I've used it for display books and the Lament Configuration so far and need more now so I can use other colours on other projects

Not easy to top up when getting low on glue

So happy with these little dispensers. They make model making so much easier .. They clog up eventually but I get a lot of use before that happens and they’re cheap enough to replace them periodically.

Ideal for model making.

Great value