iMusk 1 Pair Replacement Mini 3 Pro/Mini 3 Vibration Absorption Gimbal Camera Damper Rubber Cushion Repairing Parts for DJI Mini 3 Pro Drones

I had what most would consider a very minor crash of my Mini 3 Pro -- 3 feet off the ground and over grass. But the twig that OA didn't see knocked my gimbal/camera hard enough to dislodge the damper on one side. After watching a YouTube video for how to install this part, I decided to attempt the repair on my own rather than pay DJI to do it. It wasn't easy, but I did it and I'm now flying again. I only needed to replace the side that did not have the cable running through it, so no tools were required. I did use painters tape to hold the gimbal still while working on it. Getting the tiny holes in the damper stretched over pegs that secure it to the gimbal was the hardest part. I really had to pull and stretch to get each hole properly seated over the pegs. If I have to do it again someday, it will go much faster. It was my fear of tearing the new damper that kept me from stretching hard enough to get the job done. It is important to note that one peg on the gimbal mount is slightly wider than the others as is one of the anchor points on the damper. These must align. One mounting slit on the drone body is also wider than the others and this must align with the wider anchor point on the damper. The repair worked. The gimbal shake at startup went away and the drone calibrated successfully. So, I'm happy. I would definitely recommend watching a Mini 3 Pro gimbal repair video on YouTube before attempting this installation. I couldn't have done this repair without seeing how it is properly done first.

Very good 👍 👍

Crashed my new Mini 4 Pro and broke two of the three anchors on the factory gimbal damper. Ordered these. They arrived. I started sweating as I disassembled the mini 4. Getting the tails through the tiny holes was frustratingly difficult. I got it though, and it seems to be working fine. I’m think these are slightly stiffer then the Factory installed dampeners, but so far that doesn’t seem to affect anything. Once I build up enough nerve, I’ll replace the other side too, but I’m not ready to take the whole thing apart yet.

Quality seems good. Seems same durability/thickness as the OEM parts. I didnt end up using them because my drone was broke beyond repair but i would recommend if you are taking apart your gimbal

Excelente