SUNET 100-LED Motion Sensor Outdoor Light IP65 Waterproof Wireless Led Solar Outdoor Lights Bright for Backyard Garden Fence Patio Front Door Garage Deck Pathway Porch

Product is good but after ordering 8 pairs recived only 4 pairs at the price of 8 , product is very good no doubt , first i had orderd one set after using it for several days i ordered 8 set which means 16 lights , but got delivered only 8 light , but thankfully got my refund after chat assistant with amazon

Put one in a cabinet and another in a mini fridge, wow do they work great. As others have stated, they are very bright, the sensor works very well and it shuts off after 15 seconds of no motion. Doesn't turn on if it is already bright enough in the area. No issues with the one in the cold fridge.

These lights are a good value. They work better vertically than horizontally. The tend to fall down horizontally. But the motion sensors work, and the light is great!

Amount of light emitted was best feature. Otherwise, the battery access doors are awkward to operate & the tape does not hold well.

I purchased the 2 pack battery operated lights. They work weli and are bright enough for use under my kitchen cabinets. At first I thought they weren't working properly. But, after closing the battery compartment, I touched the lid slightly, which I think puts the lid in alignment with the batteries, allowing them to work fine. The adhesive one the 1 side is strong and the magnet holding the light is strong, as well.

The light is flickering, both of them do from the two item set I bought.There's no controls of any kind, like on/off, or motion activated only, or always on in the dark. The unit is a simple "always on (meaning watching for motion, with light off), motion activated in the dark". There's no other modes."Two ways to install": The light itself is not magnetic, it just has metal back. It comes with a magnetic strip that has a sticky tape attached to one side. Because of the thickness of that tape, that side of the magnetic strip is not magnetic enough to just cling to metal surfaces. So you can't just magnetically stick the strip to the light and then magnetically stick the whole thing to a metal surface.The two installation methods:1. This can be installed to any surface (steel or others): use the sticky side of the magnetic strip to permanently stick the strip to your cabinet, then you magnetically stick the light to the strip.2. Metal surfaces only, the location will be flexible: If you stick the sticky side of the strip to the light itself, and then use the magnetic side of the strip to stick the whole thing to magnetic surfaces.And no, the sticky side is not "3M", that's also false advertising.The cap on the PIR motion sensor falls off on both units, no glue is used.This should be sold for three dollars a piece.