Snailfly 220 LBS Roof Rack Cross Bars Fit for 2023 2024 2025 Honda CR-V CRV & CRV Sport Hybrid Crossbars Cargo Accessories Work with Side Rails

Excellent quality product! Easy installation! Fits with no issues! Looks great! If you didn't know better, you would think it was factory issue.

2025 CR-V Sport Touring Hybrid - Read information from others who rated here and followed instructions provided. Installation went very well. Some good tips in other ratings, so I encourage that those be reviewed. The horizontal fit is tight but that's what it should be. Great value.

While these bars are adjustable, they were an incredibly tight fit on my ‘24 Honda CR-V. That said, the bars are good quality. The rubber buffer they provide to put between the bars and your car (where they attach) are low quality. Overall, they do the trick and I would purchase again.

2025 CRV hybrid sports L. I was looking for a better substitute OEM crossbar. Snailfly fit the bill. This is super quiet on the freeway. Instruction is not great but the product is. CAUTION: make sure you watch the orientation of the mount . They are not interchangeable. If it’s twisted when you try to bolt on, you might have a mismatch on the crossbar mount. See picture

These are all metal, not metal and plastic. Very sturdy. They have a lower wind blockage than most other products that have plastic end pieces, so I hope they will reduce my gas mileage less than the others. I took off 2 stars because they are hard to install. The cross peices were ~1mm too long and the bolts were in a very difficult position to assemble with the enclosed allen keys. Fortunately I had a small ratchet with bits for the 2 kinds of allen bolts, but it still took over an hour to install.

I just received the crossbars yesterday and installed them in less than 30 minutes. The instructions are fairly easy to follow, but so many of the reviews gave me additional insight. They fit tightly as some have said; yeah, no noise or rattle at all. I made the bars as short as possible, tightened the underside screws before I installed it in the roof, as suggested by a few reviewers, and slightly deflected the bars to allow them to easily fit and bolt to the existing Honda CRV rails. Not sure why folks complained about the washers not being black, I didn’t use the supplied stainless steel washers at all, the washers on the black screws that attach to the rails were sufficient in my opinion - and I have tried to pull and push on the crossbars and they won’t move. Great packaging quick shipment.

Just installed these on my 2024 sport touring hybrid CRV. Like the title says excellent quality and fitment. These look as good as and I would say as good of quality as OEM.Installation is easy but give yourself time to go slow and protect your surfaces to prevent scratches.A FEW OF TIPS FOR INSTALLATION1. Pay attention to the stickers in the bars for front and rear and know that the arrows on the stickers point to the front of the car.2. Use the bubble wrap that the cross bar ends come in to protect the paint during install. Place a bag under the crossbar bracket on each side while you work to tighten the screws mounting it to the vehicle. This will help protect your paint if the crossbar slips or if you slip with one of the tools.3. The instructions say not to tighten the four small screws that secure the mounting ends onto the cross bars because they can be adjusted during install. What I’ve found on the two pairs I’ve installed on the 2024 crv is that the ends should be pushed as far into the bars as they will go and tighten the screws in that position. (Basically making the crossbars the shortest that they can possibly be. This will be the installed position for these you won’t need to adjust them from here so it’s easier to tighten the screws down before you go to mount the bars on top of the vehicle.

Installed on my 2025 Honda CRV Hybrid.Installation is little challenge , but manageable. Even with the shortest adjustment by making the crossbars the shortest that they can possibly be, the fitting is a little tight, especially on the front bar. I had to muscle it in.Make sure that you notice the “L” and “R” markings on the End CapsI sprayed the chrome washers with black paint so it looks much better.Overall, seem very solid, well made, all metal, and it looks great.