LAMPHUS Off-Road ATV UTV Light Bar Mounts Mounting Bracket Mini Bar Clamp Kits [0.75"/1"/1.25" Inch] [Horizontal Bar] [Aluminum] [2 Unit] Bull Bar UTV Roll Bar Clamp Tube Roll Cage Clamps Mount

Why did you pick this product vs others?:Good quality part that will withstand elementsBuild quality:Very robust. Well machined tolerancesLook:Great aesthetics for use in visible locations.

Used these mounts to hold off-road lights on my roof basket. Works very well, holds strong.

Solid, well built, easy to use. be careful with the allen screws and make sure not to round out the hex head.

For $9 on a 2 pack these brackets fit my needs of adding auxiliary lights to the crash/engine bars of my motorcycle. There was only 2 issues with these, first was fixed with a bit of hardware store parts and know-how. The second was one of the set screws stripped the threading right out of the bolt.The 1st issue is the inner diameter of the mounting hole where you would fit a CB antenna, bolt from the light bracket, etc is 10.45 mm in diameter (used a micrometer on both to verify). This is HUGE when the application I was using this for was a M6 bolt (6 mm diameter metric bolt). Remedy for this was a rubber bushing as I couldn't enlarge the bolt size from the lights I'm using. $4 for new hardware to marry the 2 light to the 2 brackets. No biggie.The 2nd issue is partially my fault, but also the cheap bolt provided. The metal is SOFT. Since the mounting application was a crash bar there was an inner and outer bolt in relation to the mounting position. Tightening one 2 quarter turns (space limited) and 1 a half turn, alternating between them to keep them even. Once the distance between the front and back bracket was close to touching, the bolts obviously became harder to turn, but still relatively easy with a tiny allen wrench. Then the inner one became too easy, and I knew it was stripped. Considering a bracket is supposed to be clamped tightly to secure objects to rounded tubing, this is an obvious flaw. 2nd bracket I installed with much more care knowing how soft the bolts are.Advice for the manufacturer: Steel bolts, different sized mounting hole options or at least a better description of the dimensions.Overall I'm still satisfied. And will be ordering a replacement from the mistake.

I used these mounts to replace a seat hinge on a Peace Motorsports Talon scooter. The mounts are more robust than the original cheap metal mounts. The mounts allow the seat to pivot, allowing access to the top of the engine. The mounts are well made and include all needed hardware. The rubber inserts allow use on multiple sizes of tubing, and when installed, they stay in place.

Easy to mount and robust

I used this to make a side table to attach on the bar of my day bed. It worked perfectly! I like that the hole sizes are adjustable and come with different sized rubber rings to properly fit the bar its attaching on. I had to keep sizing up on the rubber ring to get it to fit! It was a tight squeeze and needed a lot of effort to get the screws to screws but it works and fits! If you put some weight onto the side table it does slip down, so just something to be aware of. But it was exactly what I was looking for and holds my drinks and food perfectly.

The clamps are nice.HOWEVER the cap screws are way TOO SHORT for mounting properly!!I suspect this is why there are reports of screws stripping!I did go to local hardware store and bought 1/4” longer screws that allowed a very nice fit. It is interesting that the screws on the larger bar clamp are the same size. The company should have longer screws in the kit.