DC 8V 12V 24V 36V Motor Remote Control Switch for Control Linear Actuator, 433Mhz 10A Motor Forward Reverse Relay Switch（Momentary Mode）

Hooked up to RV awning. The reason I picked this one is being able to keep the factory switch Others I looked at had reviews that said both sides of motor are grounded when not active so the factory switch would have caused it to short out, this one is too but it has a place to hook switch to the unit itself and it scratches activates the relays.On the remote the buttons are a little easy to press, I pressed then several times while remote was in pocket so I took it apart and put some heat shrink wrap around the entire button on circuit board but didn't shrink it down and just kept trimming it down until I got the right feel, now the buttons have the perfect resistance.Instructions say 5 amps recommended. Not sure what awesome awning is but it's fused for way more than 5 amps. I'm only running it for a few seconds at most and the unit is pretty cheap so I'll add relays on if I fry this one

The first one I ordered had some sort of an issue, but it was of no problem. Seller sent me another one that works stellar easy to install and mount works great.

Price was right, worked perfectly to control a 12v Linear Actuator that I mounted in my attic to raise and lower the lid of a foam box I built around the whole house fan air intake ceiling louvres. Now I can remotely control when the lid is open or closed before using the whole house fan. The batteries in the remotes are not a size I’ve seen before, so I’ll be searching Amazon for these when it’s time to replace them. I like that it came with two controllers. I tried the interlock style controller first, but didn’t realize that style continues to supply voltage until you hit the “stop” button (ie hit the up or down button once and the motor keeps going until it maxes out or you hit the stop button; also, to reverse the motor / voltage, you need to hit the stop button, which becomes a pain). This is a momentary switch, meaning it only provides power when you hold the button down, which is what I wanted. The price was right and it works. I’m knocking one star off since the instructions were almost incomprehensible - I have a masters of engineering degree and most things like this just make sense to me - figuring out which wires to connect to which terminal was not clear at all and the instructions were poorly translated from Chinese and zero help. Input voltage goes to the left two terminals and the load (motor) wires need to be connected to the middle set of terminals (marked “M” if I recall correctly). I think the other terminals are for use with manual switches.

I added this to my 60" DR Power Grader as well as this https://www.amazon.com/dp/B0DDPYPPZM to be able to use Milwaukee M18 batteries. Now my power grader is not connected with any wires and I can use any of my rechargeable M18s. This was easy to install, just 2 wires on the left for the battery and 2 at the M slots, in the middle. Super fast install, took less than 10 minutes and that was getting the proper tools and adding some simple bullet connectors to some wires so I do not mess with any of the original wiring on the DR so no warranty issues.

I got this and it don’t work I have 0 red light and switch don’t work