Envistia W1209 12V -50-110°C Digital Thermostat Temperature Control Switch Sensor Module

الوصف

The W1209 is a low cost yet highly functional thermostat controller. This module intelligently controls power to most types of electrical devices based on the temperature sensed by the included high accuracy NTC remote temperature sensor.The cooler, heater or fan is connected to a power supply through the relay contacts K0 and K1, and the temperature on/off setpoints are programmed into the W1209 using the onboard Set, Increase and Decrease buttons and display. The relay contacts are then open and closed, acting as a power switch for the cooler/heater, based on the temperature measured by the NTC temperature sensor (included with the module) and the setpoints programmed into the W1209 controller.Although this module has an embedded microcontroller, no programming knowledge is required. 3 tactile switches allow for configuring various parameters including on & off trigger temperatures. The on-board relay can switch up to a maximum of 125V AC or 14V DC at 20A. The current temperature is displayed in degrees Centigrade via its 3 digit seven segment display and the current relay state by an on board LED. Settings Chart:Code: Description / Range / Default Value P0: Set Heating or Cooling Mode / C/H / C P1: Hysteresis Set / 0.1C - 15C / 2C P2: Upper Temperature Limit / 110C / 110C P3: Lower Temperature Limit / -50C / -50C P4: Temperature Calibration / -7.0C ~ 7.0C / 0C P5: Delay Start Time / 0-10 mins / 0 mins P6: High Temperature Alarm / 0C - 110C / OFF