Replacement for 1990-1997 Mazda Miata MX5 MX-5 NA | KG Works Style ABS Plastic Primer Black Rear Trunk Lid Wing Spoiler

Nice fit, Looks great! Yes, Instructions would be nice but here is my help. The two black plastic strips are to locate where to drill your holes. Place the small nubs onto the screw holes on wing (perpendicular to wing) position wing on deck lid, tape plastic strips in place. Once firmly taped down, remove wing and drill through nubs. It will make life easier if you drill larger hole on the inside of deck lid after to access bolts. Since wing in curved, it must be flat on deck lid to access holes! If you stick bolts through holes and try to set wing on them you will think you drilled holes in wrong location! I skipped the tape and just used two supplied bolts and it is very stable.

I chose to rivet this on with no sticky tape because my car was rhino lined. And it stayed on with no breaks during a car accident even. (Guy pulled out in front of me classic T-bone) looks great too!

Great price and great fit! I used the supplied 3M tape which is just enough with about 2-3 in of tape leftover. I plan to drill mounting holes later when the car is ready for the track.Installation tip (tape method): ensure surface is clean and dry then cut/install two strips of the 3M tape top and bottom starting in the middle of the spoiler. Tape the perpendicular short ends and peel the backing off (only the short ends). For the top and bottom, peel back 2-3 inches from center on each side before placing the spoiler on the rear deck (leave the 2-3 in ‘tails’ sticking out so you can pull on them later), this allows minor adjustments to get the spoiler exactly where you want it. Gently hold the spoiler in place while you peel the strips off the tape then press firmly and allow 24 hrs for the glue to ‘set’. A heat gun or hairdryer helps if you’re in a cold(er) climate. I’ve used this method multiple times on different vehicles and the tape will hold just fine; I believe it’s rated for 200mph. :)

great look on my 1990 miata, easy install

Not exactly the same as the KG Works. Mounting is different, and it came with ZERO instructions. So, I just did what I thought would work. Looks good, but would've appreciated a little direction.

fit perfect looks great

3.5 starsLooks great and seems to be made well. The supplied tape seems like it will hold.FYIBe aware that you will need to drill two sets of holes.The holes that I drilled for the spoiler to attach to the trunk are located inside the internal support structure. If you do drill the holes you will need to drill even bigger holes inside the trunk to access the other holes to the spoiler. Instructions or at least a brief description would have yielded a forth star.

Lightweight, beautifully finished, easy to install. This just needs paint if so desired and, oh yes, instructions would have been nice!