4" 5" 6" Shower Light Chrome & White 12v Transformer Bathroom Zone 1 & 2 Ventilation (4" 100mm, White/Chrome)

I've had an in-line shower fan with a down-light for years, the light used a 12V halogen lamp, that despite always having air drawn past it by the fan had seriously caused the plastic body to 'decompose' - time for a change.I was pleased to find this incorporating an LED lamp, I was almost expecting that I'd have to buy a a complete package including a fan, but not the case.This feels like a solid enough piece of kit & is simple enough to install, for ease I extended the two wires before feeding it through to the ducting. I also fed the wires tight to the side of the spigot & wrapped some insulation tape around them. The lamp is not as bright as a 35W halogen lamp but is certainly enough for the job.One other point is, best to use stainless steel screws to fix in place as my previous one had since rusted.(**** Edited 1.5 years later ****)The LED driver / transformer recently failed in my unit due to a resistor on the circuit board blowing, I considered swapping it out & soldering in a replacement but I didn't have a spare of similar specification around. As it appears the circuit board is stuck into the casing I imagined that too could suffer further damage in trying to remove it so on that basis I sourced a replacement driver.(If I cannot quote the link it I'm sure it can be removed....)https://www.amazon.co.uk/gp/product/B00BMBKHC2/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1The suppliers only give 12 months warranty. I honestly thought that I would get more than 1.5 years form the component but such is life.... If it was an excess heat issue, as it is sited in the attic, I would have expected it to blow amidst the recent very hot weather but it has been cooler now for a number of weeks.

Good price and my son fitted it easily. A few days later though the bulb had gone and found it difficult to replace as the bulb had split near the fitting element. I contacted the seller and they sent a replacement bulb and transformer but I am a little worried about safety issues. They advised me to send further photos of how it was fitted but have not done this yet as it's difficult for me to get into the loft and undo all the flooring that it's under. My son will check when I next see him but it seems to be working fine since the new bulb came. Time will tell.

We found this really easy to fit and it's a lot less noisy than the one we took out! Great little product and very good price indeed. Well pleased.

easy to fit and looks good

Good product, value for money

The main issue is the transformer; cheap soft plastic, the PCB board moves so wiring is fraught at best. Do as much preparation downstairs as possible before going in the loft. No wires from the transformer to mains supplied.The side fittings, that utilise the plasterboard ceiling board, are poorly designed and of poor plastic.It's expensive too.No cable tie (even though the instructions say there is)That said, it worked and was cheaper that buying a full kit and it did the trick.

easy to fit replaced old light without any extra work

Previous one the fitting had rusted out so bulb not working.This was fairly easy to install, now LED so cheaper to run and the chrome cover looks great.