Panda Lux Compatible with Bambu-Lab A1 LED Light Strip Easy Installation High Brightness Light Bar

This led strip fit on my a1 with no problems and is super bright been on 24/7 with no issues. Also very cheap compared to some of the other printer light setups. And it was super easy to install just wipe down with iso alcohol and stick it on. Only complaint is the sticky around the light sensor kinda sucks but nothing a little glue or double sided tape can't fix.

The lights on this upgrade is so bright that it lights up the entire room. I am able to see dust at a atomic level with this on. If you try to see the printer's camera with this on, it's like a flash bang from counter strike x100. Definitely recommend. The adhesive is pretty bad, but nothing a few seconds and double sided tape can't fix.

The glue is bad, although the light is good. The glue barely sticks for first 3 seconds and comes off

Pros: 1. Easy enough to install 2. Works great 3. Magnets stick to the frame 4. About a 5 minute process 5. It is bright Cons: 1. If designed better it would just plug directly into the printer like the original light with no extra cable or adapter board. 2. Board has four connectors which is confusing, since you only use two. 3. YouTube video glazes over the details like which connector goes where. 4. Diagrams in written instructions aren't great, and could be close up photographs. Notes: 1. The light doesn't stay on when you turn the printer back on. So you have to go into the app, for at least my P1S, to turn it back on to verify it works. 2. The original light has a clip on the connector. The new light does not. The adapter cable has both connector types. Both of the non-clip connectors plug into the adapter board diagonally from each other. The other connector on the adapter cable with the clip plugs into the printer. 3. You can tell the different female connectors from each other by looking at the connector on the printer after unplugging the original cable. Use the opposite style connectors on the adapter board.

I 100% recommend this product, it was super easy to install on both my P1S and my X1C and fits perfectly. The light it puts out is bright, even, and well color balanced. It is super easy to control, it turns on and off via the printer's light control. It makes a huge difference if you like to record timelapse videos of your prints. I had no idea what I was missing until I installed these.

The light itself is excellent and makes a big difference inside the printer. Bright, even, and looks like it belongs there. Hooking it up, though, requires some finesse and delicacy — the connectors aren’t something you want to rush or muscle through. Take your time and it’s fine. Once installed, it’s solid and absolutely worth it.

I was hopeful. Easy assembly. The pack doesnt provide an alcohol wipe to prep the surface for adhesion. No biggie I have tons of it. Lights install easy with 3m adhesive backing. The light sensor fit sort of odd, also with 3m adhesive backing. Prepped and installed. Next day went to print, walked by an hour latter and noticed the light wasnt in. Walked up to view the printer and the the light sensor has fallen off. The adhesive didnt stick. Which pulled down the light strip. I have a mess to clean up

Wow! What a difference this light makes . 100% better than the stock light I do find this item to be a great investment for all the Bambu Printers Very easy to install Easy to use and the brightness is great