GY-NEO6MV2 NEO-6M GPS Module for Flight Control with Ceramic Antenna, GPS Board Satellite Positioning Module Accessory Arduino EEPROM/APM 2.5 Compatible, RS232 TTL Interface

Works well for the price. Can be connected to anything with a serial port and 5v. The antenna is a little heavy for a drone.

Mine came defaulting to 57600 baud not the 9600 baud stated in the listing. It also came with default protocol set to UBX not NMEA. It took me a while to work out why it wasn't working with an Arduino NMEA library. If I hadn't had an oscilloscope that can decode serial protocol, I'd have thought it was broken. Having worked out what was going on it now works nicely. Would have been 5 stars if correct default baud rate and UBX format was contained in the listing

If I could leave0 stars I would didn't work no way to refund Rubbish

Good little module worked straight away originally converted to RS232 and ran a terminal program and showed all the parameters in ASCII text could then code my PIC controller and now running my bespoke clock Signal with the supplied antenna no issue so far

Easy to interface to an Arduino or anything for that matter. I wish there was an Arduino that contained one of these by default. Doesn’t come with the posts(4*) that are need to plug in to rail or circuit board.

Connected to F722 flight controller gives very good readout and with betaflight you can use return to home. Has good satellite coverage.

Antenna was dead short which caused the board to fail. Poor quality, returned

used on pi 4b and pi 5 , works well , easier to setup than expected. uses tx rx comd NOT IC2. using mine with a serial to usb converter.