20Ft Door Seal Weather Stripping, Window Rubber Seal Strip Self Adhesive Foam Tape for Door Window Gap and Wind Blocker, 3/8-Inch x 1/4-Inch x 20-Feet (Brown)

It works very well but I had to tack the end down to get started because it kept pealing off. Once I tacked the end down it was ok and the rest stuck ok. It may have been the cold weather stopping it from sticking on the curled end.

Good material, but doesn't stick well to some surfaces.

I had a number of double-sash windows with deteriorated weatherstripping/seals that were leaking lots of air. I used this product to fill gaps about 3 to 4 mm wide at the sides of the window sashes. The old seals were in place, but they'd become brittle and were leaking air. (I left the old seals in place.)I pressed strips of this product into the gaps WITHOUT removing the backing over the adhesive. Since the product easily compresses from about 6 mm down to 3 mm, and because it is very spongy, it stays in place due to the mechanical pressure. Air leaks are gone.I also stuck the product in place, using the adhesive backing, at the top of the top sash and the bottom of the bottom sash. Time will tell whether the adhesive will hold.NOTE that opening or closing the windows will cause the side strips to fall out. So, this is a solution for windows that stay closed during the cold weather months -- which is the majority of the windows I used the product on. (And, if a window has to be opened, it only takes a minute to reinstall the strips at the sides of the sashes.)

I think this double 1/4" strip will be what i need to seal my front door. The adhesive on this strip is lousy. I had you use Gorilla clear adhesive to hold it to my door frame. It is possible this strip has been is storage for a few years and the glue dried up? Be aware when buying that you will need to add glue to the strip.

What a waste, this is not sticky at all and won't stick to the door area I need to weatherproof. Now I have to buy something to help it stick. I should just return it instead. It sucks thought that I already scrapped off all the weatherproofing that was left, so nothing on there now to keep the cold out till I get adhesive

The adhesive is very strong. Place the strip on its properly aligned final position with the backing strip on, then peel it off a little at a time while making sure the strip stays aligned. It is hard to get off and reposition but not super difficult.It didn't work for me because it was too thick for my needs.Overall, it seems like a high quality product.

Works if it sticks. The adhesive is old or not made well enough too old to the door frame.

Ordered these for a friend, they used them on one of their AirBNB's and it works as expected to help keep the air out. 5-stars