Suggested Use: Step 1 Please wash your hands. Fill the clean bottle with the designated volume of warm distilled water, filtered water or previously boiled water. You may warm the water in a microwave but they recommend that you warm it in increments of five seconds. This is to avoid excessive heating of the water and damage to the device or scalding your nasal passage. Always Use Distilled or Micro-Filtered (through 0.2 micron) or Commercially Bottled or Previously Boiled & Cooled Down Water at Lukewarm or Body Temperature. Please do not use tap or faucet water when using NeilMed's nasal wash devices unless it has been previously boiled and cooled down. Step 2 Cut the Sinus Rinse mixture packet at the corner and pour its contents into the bottle. Tighten the cap & tube on the bottle securely, place one finger over the tip of the cap and shake the bottle gently to dissolve the mixture. Step 3 Standing in front of a sink, bend forward to your comfort level and tilt your head down. Keeping your mouth open without holding your breath, place cap snugly against your nasal passage and squeeze bottle gently until the solution starts draining from the opposite nasal passage or from your mouth. Keep squeezing the bottle gently until at least 1/4 to 1/2 (60 to 120 mL) of the bottle is used for a proper rinse. Do not swallow the solution. Step 4 Blow your nose gently, without pinching your nose completely because this will apply pressure on the eardrums. If tolerable, sniff in any residual solution remaining in the nasal passage once or twice prior to blowing your nose as this may clean out the posterior nasopharyngeal area (the area at the back of your nasal passage). Some solution will reach the back of the throat, so please spit it out. To help improve drainage of any residual solution, blow your nose gently while tilting your head to the opposite side of the nasal passage that you just rinsed. Step 5 Now repeat steps 3 & 4 for your other nasal passage. Step 6 Clean the bottle and cap. Air dry the Sinus Rinse bottle, cap, and tube on a clean paper towel or use NeilMed NasaDOCK or NasaDOCK plus (sold separately) to store the bottle, cap and tube. INGREDIENTS 100 regular premixed packets of pH balanced sodium chloride & sodium bicarbonate mixture (USP grade, natural ingredients, isotonic, preservative & iodine free) Educational brochure Instructions in English, Spanish or French WARNINGS WARNING: USE ONLY AS DIRECTED, IF SYMPTOMS PERSIST SEE YOUR DOCTOR/HEALTHCARE PROFESSIONAL. ALWAYS READ THE LABEL. WARNING: Please Read Before Using. Always rinse your nasal passages with NeilMed SINUS RINSE packets only. Our packets contain a mixture of USP grade sodium chloride and sodium bicarbonate. These ingredients are of the purest quality available to make the dry powder mixture. Rinsing your nasal passages with only plain water without our mixture will result in a severe burning sensation as the plain water is not physiologic for your nasal lining, even if it is appropriate for drinking. Additionally, for your safety, do not use tap or faucet water for dissolving the mixture unless it has been previously boiled for five minutes or more as boiling sterilizes the water. Other choices are distilled, micro-filtered (through 0.2 micron), commercially bottled or, as mentioned earlier, previously boiled water at lukewarm or body temperature. You can store boiled water in a clean container for seven days or more if refrigerated. Do not use non-chlorinated or non-ultra (0.2 micron) filtered well water unless it is boiled and then cooled to lukewarm or body temperature. Do not rinse if your nasal passages are completely blocked or if you have an ear infection or blocked ears. If you have had recent ear or sinus surgery, contact your physician prior to irrigation. If you experience any pressure in the ears or burning in the nasal passages, stop irrigation and get further directions from your physician. Keep out of reach of children. Read and retain this en
ترست بايلوت
منذ شهر
منذ يوم واحد