How much heat can this handle after fully curing?

Not much at all! If you make an ashtray out of it, putting one out will cause the epoxy to yellow and get soft/sticky in that spot.

What is the cure time?

For a seal coat, I waited about 3 days before I added additional layers. The last pour was about 1/4 - 3/8 inch and I let it set a week before doing anything with it. The epoxy was hard within a day or so, but I don't know if it would be cured all the way through.

Will this work for a 2” cork table?

Yes, it will work for a cork table. Make sure the corks are secured to the bottom surface otherwise the corks will float. You may need to tend to it with a heat gun as air bubbles will continue to rise up to the surface due to the gaps in the corks and epoxy filling in underneath. We recommend checking on it every 15 minutes at 70 F within the first hour of pouring to release air bubbles. Hope that helps!

After the resin is mixed, how much working time does it have?

Thanks for the question. There is approximately a 30 minute gel time at 77F. To be safe I'd assume about 20-25 minute pot life depending how much you mixed up. If you mixed a lot of epoxy together it would be a bit quicker; it would also be quicker if the working temperature was over 80F. I hope that helps. Let us know any other questions!

Table Top

التفاصيل

الوصف

الأسئلة الشائعة