Arnold490-322-0004 8X1.75 STL Offset Wheel

I used these on my lawnmower. Don't waste your money buying cheap ones. I did and they were broke and floppy after a year, I didn't even mow that much due to a drought.They fit good, I did need an extra washer. The one provided was very close. But that's me.Completely worth the cost! They will out last the mower, which is already 15 yrs old but going strong.

These are replacement wheels for a collpsible cart that I use to tote large musical instruments (tuba, euphonium) and other concert gear in. The original wheels had plastic hubs which disintegrated. I had to machine new axle sleeves to make these wheels fit, but now While they are a bit heavier than the old wheels, I'm very happy to have them on my cart. I expect them to last for a good while.

These are good solid rubber and steel type wheels. Mine had no plastic or thin metal at all. The center, where the axle goes through is metal lined double and is also better made and sturdier than my previous wheels

After research on terminology used (offset hub) I bought these and they were Perfect

I got these for a PowerSmart Push Lawn Mower Gas Powered, 21 Inch Gas Lawn Mower that the rear wheels literally fell apart on. I put these on, and they became the best part of the mower. I would definitely get these again.

I had plastic wheels on my generator as shown in 2 of the pictures. One wheel cracked a couple years ago, but still worked so I was careful when moving it. The second wheel cracked when I was turning the generator around this past weekend for annual fall startup. It failed completely when I continued pulling out of the garage where there is a slight bump. Second wheel (that was previously cracked) then failed when weight shifted. Design problem somewhere, plastic became brittle? Carried generator back into garage and then I found these metal wheels which should never fail. Local T.S. store had plastic wheels in stock that looked similar to what I had previously, but for same price and no need to make an 1.5 hour round trip to the store I tried these metal wheels from Amazon. The original wheel was 7-3/4" diameter, so 1/4" larger was no problem. Wheel comes with (1) washer and (1) 11/16" long spacer as shown. I ended up adding 2 additional washers behind the wheel to make it tight to the cotter pin as shown. The bearings allow the wheel to move a little bit side to side, but not enough to cause any performance issues. The plastic wheels were stiff in comparison. Bore hole for 1/2" shaft. I'm happy to have the generator repaired with steel wheels that should never fail.

worked perfectly after several tries with ordering the wrong wheel width. This one was perfect.

Fast delivery

Lo use en una podadora marca Toro y funciono al 100%