DAYKIT 10 pcs Speaker Wire Cable to Audio Male RCA Connector Barrel Adapter Jack

These work OK and make it much easier and faster than trying to solder superfine wire. HOWEVER....THE RED AND BLACK ARE OPPOSITE!!! Reverse them and BINGO!

You can go old school connection or wire tip to you speakers in 30 seconds 😜

Installed some today and work great

Pros: Super easy set up, push the buttons, slide the wires into the slots, done. Perfect sound tested and sounds the same before and after using the adapters.Con: Only one. Either the plugs on my specific application are too close together, or these adapters are a bit wide. I had to use three extra adapters on one side because I could not plug in two of these next to each other. They measure 9/16 x 12/16 inches. I estimate you can plug these in back to back, to female outlets that are at the very closest, 1/2 inch from each other at center (see attachment).

Works for me . screws feel very cheap however . I strip them evertime , I use the right size Phillips and I dont turn into the ultimate hulk once I start screwing (no pun) I screw normally with a screwdriver I dont use my drill for.this . it's not me the screws are just very cheap. With that being said if you dont screw em in properly they will become one time use

Exactly what I needed. Thanks

had one faulty unit with a bad negative side switch. Other than that works great.

Great for retrofit of system with RCA outputs to speakers. Or if longer lengths are needed.