معلومات عنا
دعم العملاء
احصل على التطبيق
قم بتوجيه الكاميرا لتنزيل التطبيق
حقوق الطبع والنشر © 2024 Desertcart Holdings Limited
A Rigid plastic candle mould for making round pillar candles, 100mm x 60mm high, great value in candle moulds and ideal for beginners. For use with wax at 82 degrees or below. Do not use alcohol based fragrances with this mould. See wicks , wicking needles and mould seal elsewhere on this site Suitable for either natural pillar blend, paraffin wax or 100% stearin candles. Candle should release when 100% cooled , if difficulty in removing the candle place in the freezer for a few minutes. Clean excess wax from mould after use.
E**E
pm13 pillar mould
the only problem with these non see through plastic moulds is if you want to mix wax levels you cannot see through even though you can use accurate measuring units
M**N
Wax sticks to mould
The wax stuck to the mould and could not easily be removed. This happened on several occasions, despite various approaches (using other non-stick products etc.)
L**Y
Three Stars
As expected
L**Y
candle mould
it is an alright bit of kit to make pillar candles wouldnt buy another one though as it can be quite messy getting the candle out of it.
ترست بايلوت
منذ 4 أيام
منذ شهرين