Silicone Ball Mold, DyAi 9Pcs Resin Epoxy Mold, Universe Spheroid Moulds, Orbs Pendant Casting Molds for UV Resin Crafts, DIY Jewelry Making (20mm/ 25mm/ 30mm)

Not sure why people have a hard time getting the hardened resin out of these molds. You need to take your time and work them out slowly. If still having problems use a little dish soap and work the soap down into the mold and still working slowly they will come out very easy. You also want to make sure that your resin is fully hardened before attempting to get them out.

Made eyeball keychains and magnets (and necklaces) for Halloween. They turned out great! No problems getting the pieces out of the molds and the molds held up very well. Going to make these again next year!

These make a great sphere, but demolding is difficult and one mold tore after only two uses.

Very good in all ways

Literally perfec for making orbs/balls/sephere with resin. Comes out pretty easy considering the hole to sephere volume ratio. All in all I am very happy.

I’m so disappointed in these molds. The first time I used one, the lip tore when I tried to remove the resin casting I had made. The opening for removal is too small. I had an extremely difficult time even getting the opening opened up for removal. Anyone have any tips for this problem? I have watched a lot of resin YouTube videos, and no one else seems to be having that much difficulty removing a casting.

ordered by mistake

The silicone is thin making them flimsy but the problem is the bottom is not flat and they will not stand on their own - they topple over without anything in them. I was going to return them but decided to try gluing them to a base and see if that will work. I have some scraps of silicone from molds I made. Will update if it works.