NYLL 3 ft T8 G13 Type A Plug & Play LED Tube, Daylight (6000K) Direct Replacement for 30W F30T8D, F30T12/D, F30W/865, FO25/865 (Without Rewiring or Modification) Ballast Required!

Worked perfectly with no rewiring. Easy to install, fit was very good, true daylight lamps are very bright, perfect for m under desk lamp.

My work shop has a single neon tube , 36" ballast which has been in the shop since I moved in the house 27 years ago. Never threw off much light so about 4 years ago I replaced the bulb with a modern neon gas "bright white" bulb. An improvement but still not enough light. I would usually end up working with an additional "flexible light" or holding a flashlight in my mouth. Ordered this LED in DAYLIGHT 6000K and its a direct replacement. No wiring additional parts as other LED bulbs require, just twist it in! When I turned on the light all I could say was WOW! No more flex light or flashlight in my mouth. This one LED bulb lights up the entire shop like theres no roof during a sunny day. The light is pure white and slightly soft. Doesnt hurt your eyes and no silly blue tint. Absolutely amazing! I wish this LED existed 27 years ago!

Direct replacement for fluorescent tube

I used the luminaires to replace the existing ones in an old pool table light that had odd sockets and can't be retrofitted easily. They work well with the existing ballast with no flickering and were as simple as a bulb change. The 5K temperature really lit the table well. I just wish they had been a little more economical.

Very, very pleased with these bulbs. Really bright and light up the work area on my workbench! These are more expensive than some, but a good value in my opinion. My light fixtures were mounted on the bottom of cabinets over the bench and I did not want to replace the fixtures or do any rewriting (difficult access). These filled the bill, slipped right in, and I am a happy customer.

Wow simply amazing the difference between the old 30 watt florescent and this bulb! Just in the light output and brilliance of white light that's emitted off this bulb running. Runs a lot cooler then the older florescent bulb not giving off much heat at all, and just the fact I'm saving half the cost it takes to energize this one over the other is a big saving! No rewiring like other Led bulb replacements either (just plug in and play) easy peazy! Used as a cabinet light. Thanks again to New York LED Luminaries!

It is a direct replacement, but with ballast still in the loop, it makes the same noise as using the old tube. Secondly, this tube is in the closet with an infrared switch. the tube sometimes does not fully turn on. It just glares as the picture shows. I would rather modify the wires and use LEd tubes without ballast.

Works as advertised. No wiring necessary. Just pop this tube in where the fluorescent bulb was located and it works like a charm. Nice and bright!