OriGlam Adjustable Two Jaw Bearing Gear Puller Remover Tool, 2 Inch Carbon Steel Pump Removing Kit for Motorcycle (2 Inch)

I was pleasantly surprised at the build quality and sturdiness of this puller. I needed to replace a gear on a car sunroof window motor, which was pressed on tightly. It worked without a problem. This is perfect for small gears and pulleys. It is both stable and durable for any small, tough job.

Great product

The quality you would expect for a inexpensive tool from China. It did the trick pulling a rear windshield wiper off. It is fine for intermittent use at home. If used on a daily basis I would get a higher quality unit.

I have a very old Drill Doctor 750 whose diamond wheel I needed to replace. No matter how hard I tried, I could not get it off. I have other pullers, but none the right size. This gear puller was exactly right for this job. With just finger pressure, it came right off. I don't expect to use it often, but it saved the day today.

I've bought a lots of tools that I will probably use one or two times in my life. To save a little money I will sometimes buy items made in China. This gear and bearing puller was the WORST piece of crap I've ever received. I was working on a deadline and didn't have time to wait for a replacement thought I doubt it would have been any different the second time around. One of the "jaws" was a full millimeter longer than the other. The crossbar had only been finished on one side, so the jaws wouldn't slide all the way to the center like they are suppose to. I actually had to take the crossbar to my grinder and remove cast iron until I could get the jaws to center and reduce the top surface enough that the jaws were aligned. Granted, it only took about 10 minutes to get it ground down and trued up enough that is was "usable". The center screw came with a point on it. After pulling the first 16mm x 10mm pully from a 5mm shaft, the "point" was now about 2mm across. After the second pully it was at least 3mm wide! I don't know what grade of steel they used, but it was VERY soft. Really total junk after two small pullies!!

did what it needed to do at a very good price. quick shipping

Worked well to pull bearing off table saw armature. Arms are loose fit and wobbly. OK for light home use.

Great tool and it works very well.

Conforme à la commande

Stabiler, kleiner Abzieher. Variabel in Gebrauch. Hat sein Zweck beim Abziehen eine DM 25 mm Kugellager im engsten Raum erfüllt. Bin zufrieden!

Very cheap, used it on a rega 3 record player to change the motor rotor and it worked perfectly. The official tool was about £40 this was far far less

Very happy with it thanks

OriGlam Adjustable Two Jaw Bearing Gear Puller Remover Tool - high-quality tool and highly recommended.