Pattern Flush Trim Router Bits 1/4 Shank, Bottom Bearing Pattern Router bit Set, 1/4 Flush Trim Cut Router Bits, Handy, Durable & Sharp for Home DIY

This set works perfectly. I used them to cut in windows and door opening of a garage. Good quality product.

Very good router bits good price fast delivery well packed

I used these bits for trimming a routing table insert into a routing table I built. They worked well for this application. However if I was to do more frequent projects like this I would get a higher quality bit. If you want to use these for similar one off projects I would highly recommend. If your going to do these projects more frequently I would recommend a higher quality bit. During my experience with these I saw some burning of the bit and had to tighten the bearing a few times but overall they achieved the job I wanted. If I have similar projects with one off cuts I will get this brand of bits again!

I decided to install my first pocket door and one thing I quickly discovered after tearing into the wall and buying a slab door was the need to make some jigs and rout for the handle and pull hardware.Despite my collection of over 36 router bits, a number of which I have never used, I didn't have any of these - flush bits with a guide wheel at the shank instead of the tip. This turns out a perfect collection for pocket door hardware, and the assorted sizes - I thought them a little overkill - turned out to be a godsend as I used three or them for this one small project.I did a couple of test cuts on scrap and it's a good thing I did, just to get used to using these for two depths (shallow on the outside and deep on the inside). To my surprise, I found it better to cut the smaller, deeper cuts first so I could get a better site on clamping my jig for the next wider, shallow cuts.These came sharp sharp, each in a nice and secure little clear case. Deep shanks for good purchase. No idea how long they will last but for this first project, much better suited for my task than I realized when placing the order. Very satisfied!

Worked

Probably good for the price, edges chip very easily, lasted just long enough for some plexiglas templates.

I used these bits for fixing the edge of my desk I built and pattern cutting all that but I also used these bits to make holes in my desk (not what it’s used for) and it held up well it was hard to control my cuts cause I was trying to take off more material than the bit can handle but the bits are still sharp and perfect. Would recommend

They are not bad for the money, BUT, my first cut with these was on a small piece of maple, routing out a 3" circle. In 30 seconds the bit broke on the bottom edge. I just used a longer one and adjusted the router to finish, but they should not break cutting 1/4" into maple. Amazon/seller replaced the set, but common man!

I needed to install an under mount sink on a butcher block countertop. And to finish the cut Perfect, I made a jig, and the Cut could not have been a cleaner cut. Really finished the project off perfect.

exellent