MakerShot Magazine Speed Loader, Compatible with 9 mm - CZ 75/85 / P-01

I ordered for the CZ75 magazines and got the "B" size. Fits good with simple instructions written on packaging.1. Insert fist round by hand2. Place speed loader over magazine3. Press Speed Loaded down (thumb saver)4. Insert new round under feed lips until hit speed loader "plunger"5. lift speed loaded until the "plunger" is above the round and you can then finish push the round to the back of the magazine.I was also able to use with the CZ82 magazine, but since the magazine is shorter there is a some wiggle room front to back and you need to pay attention to line it up correctly. If I still like this after using it for a bit I will try to get a 380 version to see if it fits the magazine better.

great design and quality ingrediants

Does the job, but a bit loose and wobbly for my CZ 75 magazines. I expected a tighter fit based on picking my exact model. After using for a while you get used to it and it does do a great job loading rounds. I opted for this model over the more expensive speed loaders and it works fine.

Doesn't work well with single stack magazines. Designed for double stack 40 cal., 9mm & 10mm ammo.Doesn't work with .380 ACP, .32 ACP OR .45ACP ammo.Not as easy to use as advertised.

There is nothing extraordinary about this device. It makes loading those last few rounds into a high capacity magazine possible, instead of painful. There are slicker quick loading products on the market, and none of these is cheap, but my thumbs are finally getting a break. It's worth the money to save your thumbs, but it's a little annoying that it probably cost a dollar to make.

Worked well for 3 mags of 16 for a CZ 75B Omega’s magazines. Only time and use will tell if it lasts.

Product does not make it easier. With the super tight tolerences it's 1. Diificult to insert the magazine. 2. Even more difficult to load a bullet.3. the maker shot device struggles to slide along the magazine even with a bit of gun lube.I threw it in the drawer of unused items that I'll never touch again. Just a waste of money and "they got me". It's far easier to load by hand compared to this plastic junk.

I do not recommend MakerShot version for CZ 75 P-01. Why? It just does not work very well. When it presses down on bullet rear, to make room for next bullet, it causes bullet front tip to lift up so that it blocks the next bullet from being insert, therefore, you still need to use your thumb to assist inserting the next bullet by pressing down on bullet tip. That defeats the whole purpose of this product; to save wear-and-tear on your thumbs. I bought MakerShot hoping it would work just as great as the Springfield XD 9mm OEM Magloader that comes factory included. They have a similar design, but it is no contest. And, on top of that, if you buy more than one MakerShot for different make/model magazines, your not always going to be able to tell them apart because they do not imprint the Make/Model(s) onto to plastic.