Leviton QuickPort Decora Insert, 6-Port, 41646-W, White

So glad to have loose wires terminated and in a nice wall plate. Looks great and works well.

I used a few of these to replace existing plates because they offer far greater customization than the usual pre-built ones you get on various wall plates. I used these for HDMI, COAX and network jacks to outfit my tv wall plates with all the plugs I needed to get things connected. I did have an issue with one plate where the metal screw port popped out of the plastic, but it happened because I mounted my tv over it and HDMI cables were pinched so tight it was pushing too hard on the wall plate. This was resolved by moving the tv over slightly, but I did have to purchase a new Keystone plate. Other than that, they fit great in existing setups and the keystones all fit snugly inside.

Sure- you can buy keystone wallplates all day long and there are tons of brands, but at the end of the day these are STRONG and are made to very tight tolerances. This is from experience - had two different 6 port keystones that I could not get 3x HDMI, 2xLAN, and 1x Optical Cable keystones to fit properly - or if they did, the plastic flexed so badly when putting pressure on the ports that the keystones would just pop right back into the gang. Switching to the Leviton cost me a few bucks more but the keystone jacks snapped in with a very solid click and didn't move around at all once installed. For my 2 port jacks it was not as bad but when you start cramming in 6 ports to a single gang it can be problematic - with the Leviton I have no complaints.

The quality is nice. Keystones snap in tightly and even when full with 6 keystones, flex isn't excessive once mounted in the box. Just be advised that large keystones might not fit top-to-bottom or side-by-side. For example, multiple Cable Matters® Cat6 RJ45 Punch-Down Keystone Jacks do not fit without modification. To make them fit, one has to trim off the little two plastic nubs on top and grind down the side to about half its existing thickness. I used a Dremel tool with a little sanding drum.

I was skeptical getting this after reading some reviews. Was afraid my keystones wouldn’t fit nicely with this plate. But for 5 bux, I’d figured id give it a shot and I’m glad I did. Works nothing short of perfect with Cable Matters shielded Cat6a keystones. Thusly, works perfectly with the 2, 3 and 4 port versions as well. Can’t speak intelligently about other keystones though. If you have the above mentioned keystone, don’t hesitate to get these. Saved me some work having to cut into my wall and add more low voltage brackets/keystone plates.

We wanted to match the brass plates in the rest of room and most AV/ethernet wall plates are white or almond. With a decora brass plate and this as the insert it matches perfectly. I got some quickport inserts for speakers and Ethernet, though I did have some standard keystone jacks but wasn’t sure about compatibility. Based on reviews many standard jacks work so ymmv.

While I recognize that 6 keystones on an insert is a high density for an insert, it should be noted that the configuration puts the keystones so close that some RJ45 keystones don't work when sitting next to each other

These work beautifully for installing speaker jack, data, and HDMI keystones. I usually trust most low voltage products made by Leviton. I am a professional A/V installer and use a variance of these almost on a daily basis.These, like most keystone plates are clearly marked Top to make it easier installing your keystones jacks.They are made out of quality plastic and I am yet to break one when installing. The tabs where the mounting screws fit, are made from a softer plastic that allows for some flex, to relieve stress when plugging in cables to the keystone jacks.These come with screws needed to secure the insert to your low voltage bracket.