DPS 5HP MY-PS-5 Used for 3HP(2.2kW) 9A Motor, Single to 3 Phase Converter, 1 DPS Must Be Used for 1 Motor Only, Input/Output 200-240V, UL Listed

To convert three phase to single phase For Delta shaper it worked perfectly in my application

I hooked this up to a 3 hp lathe, tested the motor once wired and it worked. When I went to use the lathe it ran for about 10 seconds, unloaded just turning the spindle, then began to stutter and the DPS went POOF and blew out white smoke and insulation, catastrophic failure of some internal component.

Hooked it up to my 1967 Clausing lathe and no worries no hassle just worked , Good bang for the buck

I purchased an expensive but used industrial-sized fume extractor and when called the electrician out to hook up a 220 outlet he informed me that the machine was 3 phase and it would cost "thousands" to get a converter and told me I should just scrap it.Well I took a chance and purchased this, hooked it all up completely on my own, was really easy, and it runs perfectly. Don't expect great instructions and make sure you know exactly what HP your motor is, but it works. Normally this stuff never works out right for me but this time it did.

Brother bought tire balancer and didn’t realize it was 3 phase. Told him we have to convert it to single phase. Installed this inside tire balancer to get three phase from his single phase supply. Works great!

the chart for this product says 9amps but the lable on the product says 15amps, will blow fuses all day long.

3 phase motor on a tumbler 6 amp draw ,The motor would not turn fast enough to generate the 3rd leg of powder due to heavy start up load. THIS WOULD WORK IF THE MOTOR YOU INSTALL IT ON DOSE NOT HAVE A HEAVY LOAD ON START UP. like a fan ,mill, drill press ECT. low load on star up. will not work on tumbler ,air compressor ,primed pump etc.. the seller did not list this. I install different kind of phase converter and my tumbler ran fine. SELLER NEEDS TO LIST THIS SO NO ONE WAST THERE TIME.THEY HAVE TO KNOW.

This product has been working well as a 3-Phase converter for my 3HP milling machine motor. My only objection is that there is no "pass through" ground terminal.