Heavy Duty Rubber Glue for Bonding Rubber and Other Materials - Instant Super Adhesive for Tire, Boots, Belt, Foam, DIY Crafts, Rubberized Speaker, Tube

My brake hoods on one of my vintage bicycles developed a tear and I found this product, deciding to give it a try. I followed the instructions and now the tear is almost invisible to the eye. The hoods are black, so this glue was an ideal match. I clamped the hood for a couple of hours and after that, it was dry. So far, after many rides, the repair is holding.

I used this to create rubber belts from strips. It is early days but so far, the belts are holding up perfectly under some stress.

Tried to put a torn piece of my tire back on. Works pretty good, takes about 10-20 seconds to bond. Had to redo it one time so far. But it is on a tire. So a lot of heat and abuse plus tire cleaning and shine products have been put on it.

Bought this to glue nylon strips to an aluminum frame to make a glass rack at my shop after trying several different adhesives and lots of overnight clamping. Nothing was holding. THIS STUFF IS AWESOME. Just put a few little drops along the back of the nylon, pushed for maybe 20 seconds and the rubber basically fused itself to the aluminum. Tried on several different materials including glass and saw the same or even better results on glass. Just ordered another bottle to have around the house.

This "rubber adhesive" simply does not work. I made several test bonds by making a clean cut in the rubber I was intending to bond and then gluing it back together using this product. I used a new blade, after cleaning it with solvent, to make the cut and applied pressure to the bond for approximately 30 mins. It appeared to stick but just a small amount of tension separated the joint.

Had a pair of insulated rubber hunting boots that the sole part was separating from the upper part.Cleaned the surfaces with alcohol where the glue was going as good as I could.It was a lot of surface to glue because the sole was almost completely separated. Used maybe half the bottle on the 2 boots. Used duct tape to hold the sole in place and let them sit over night.They are like NEW!!Worn them a lot since and I think they are holding up great.

Nothing special about this. Doesn’t bond any different than any other glue. I was using this to bond rubber to fiberglass and was having to put a lot of pressure on it for quite awhile and still not getting the bonding I was looking for.

This glue has held up so well that I think I will not need to reglue my RC tires ever again. I used this on a set of tires for my Traxxas Slash 4x4 vxl and was ripping on them for hours without a blowout. will be using this glue exclusively for now.