LED Driver Transformer 240V - 12V Including MR16 Connector / 240v AC to 12v DC / 0.5w - 12w / Zero Interference with Dab and WiFi

Very simple to install. The fact that the connecting cables are already installed makes fitting very easy. Not all similar products are already wired.

Used for under cabinet lighting. I cut the ends off and used wago connections. By removing the blue end caps and centre body, you can see marked the positive (live) and negative connection.

Works well and a cheaper alternative to others.I wish I had tried these first instead of the constant voltage LED drivers I bought for one bathroom which were more than 3x the cost.Quality looks good, pre-wiring saved a lot of time.Only difference between these and the expensive ones I have is there is a tiny delay between pulling the cord and the lights coming on (maybe 0.3 of a second).Last comment - these are not boxed and have no data sheet or leaflet. They arrived loose in a cardboard "pocket" with no protective packaging whatsoever. They were moving around freely and I wonder how much of a battering they took in the shipping process. That said all 3 worked fine with 5W MR16 LEDs from Toolstation.

I'm slowly in the process of replacing all the Halogen downlighters (over 50 of them, courtesy of the previous owners) with LED bulbs, to eliminate buzzing and flickering new transformers were required, for which I've used these.Fitting is simple, after cutting power at your main fusebox, cut the cable connecting the mains supply to you old transformer, strip the wires on your mains cable then connect both the stripped mains cable and the 240v cables of the transformer via a junction box. Don't skimp and just splice the wires then wrap with electrical tape, there is a (admittedly small) fire risk from doing so as tape does slowly degrade over time.

Economical transformer for use with LED lamps. Good value for money and EU quality assured. Works perfectly, stepping down 240 volts to 12 volts supply - straight forward to fit. This type of transformer is essential if replacing 12volt halogen lamps with LEDs, and you wish to avoid lamps flickering. This particular transformer is non-dimmable, and works with LED lamps rated up to a maximum of 12 watts. I thoroughly recommend this product.

did the job

Worked well, Easy to connect as advertised. Sadly one of them "blew" after a couple of hours; but the rest continue to do their duty.I dismembered the blown one, and the build quality was obviously poor, with a very scruffy-looking circuit board. Probably a QC issueJust about acceptable considering the low price

This fits the specification & has been in for a while now without issue - driving a 12 Volt 3 Watt MR16 LED spot light.My 18 month old unit failed (so out of warranty), I identified the transformer / driver had failed due to a single blown resistor. I chose not to bother repairing as it was not that easy to obtain a single resistor without a trip that surpassed in driving to obtain / getting delivered reasonably priced parts or ending up with 99 spare resistors!