3M Scotchgard Clear Paint Protection Bulk Film Roll 12-by-84-inches

This material is easy to work with and protects the paint well

Good product

Excellent protection. Good transparency. I used this on our sliding patio door. The dog was jumping on the door and scratching the glass. I tried a clear shield from a pet supply but in no time at all that was covered in unsightly scratches. Installing went fine per the instructions. If the price was lower I would rate this a five.

Super fault tolerant. MUST use soaper water, makes it sooooo easy!!! Stunning results.My learning process:I cut the shape myself, it's easy to process.Then for the first time I used pure water, and I have 0 experience, tons of bubbles and wrinkles. I was so disappointed but I knew it's because of my lack of skills. Immediately I peeled it off(carefully) and reapplied with more water, the result was instantly better, with only bubbles but no wrinkles, It's impossible to remove the bubbles though.On the next day, I was told I should use soap water. So I carefully removed it again, this time it's more stubborn, I felt I was about to stretch it too hard and actually tear it. But in the end, with tons of water, it recovered and doesn't look like over stretched.So I applied some soap water and reapplied the film, man that was so much different, it's so easy and literally took me like 5 mins to get it in the perfect place. With a credit card I removed all bubble/soap water underneath and result is amazing. I can't believe I have removed this same piece twice and it still worked!!!I am very confident now, I am going to buy again and apply to the front of the car.

After watching video it was very easy to install. I did all four corners of my 67 Mustang and it protects all the areas great, so far there hasn't been any delamination.

It has been a few years since i have used any film but this was really easy to use, well, except the area's that had compound curves it took a lot of work to get it correct... The product is totally invisible except where the film stops, but if you can put the film edge on a curve or edge you cannot see it at all....Just make sure you keep the surfaces wet and once in place work all the slip solution out....

I did not buy the right size. That made it harder to install.

Ordered two rolls installed first and saw trash under it. Thought I did something wrong. Peeled it off and opened second roll noticing lots of contamination inside the film before even peeling backer paper. Would not recommend