XmuxHai 4PCS Waterproof Universal Door Protector Automotive Molding Trim, Black, Painted Plastic, Door, Side Body

works well

First note they do not use 3M tape. The ‘adhesive’ is a goop that can easily come off the product while pealing off the red seal which made for a very frustrating install. Provided the corners cut I don’t think this will last. Best recommendation is to measure and mask with painters tape to make sure it turns out level and even across the body of the car. Good luck!

I never had better edge protector than this one.It's fit great to my new 2023 Skoda Fabia and looks perfect.It's hard sturdy flexible to band it as you wish and keep my door protected.

I was a little disappointed that these were folded up in a box and shipped to me. Out of the box, they were bent in the shape of a “U”. I had to take my heat gun, lay them flat, and get them flat again. That is gently heating them.TipsYour car door needs to be washed and dried. You need a very clean surface.Let your car sit in the sun to warm your door. The adhesive will stick better.You need to put a straight edge on the car door to find where your car door curves out(see picture). Mounting them in the wrong spot will offer no protection.You need a sharp knife to peel the backing off the tape. It is VERY sticky. I literally had to hold down on the sticky part, and peel off the backing.Do not mount them level or use a level. My car slopes to the front end. Follow the contour of the door, that is lines on top and bottom. I measured from the crease of the door at the top to the door guard.You can lightly do a dry fit, and remove if needed. Once you have a good position. Roll with your palm across the door guard for a snug fit.Quite happy. The material is a hard rubber. My car is gun metal gray, and it matches up well.

Looks great .stays on.