Molex (2-Circuits) Male & Female Receptacle Plug, w/Terminal sockets w/18-24 AWG Standard .062" Pins, Pitch 3.68mm (Pack of 6 Set

Not much to say hereGreat value for the money good build quality and a perfect fit for my projectNo issues would buy again

These are the smaller of the connectors, measure between the pins to be sure what you need. They are Molex, they fit tightly with good crimpable metal pins and do not have the latching arms. A nice set of ratchet type crimpers might be a good idea if you are going to do this a lot. These fit wire around 16 gauge and would work for lower currents.

I don’t know what happened to the plug that was on my lawnmower headlight harness, I guess a mouse chewed through the wires and ran off with the plug. This product works great as a replacement, I don’t have any molex crimpers so I just carefully mashed them with some needle-nose pliers.

The Molex connectors were difficult to seat the metal pins. I had to slightly enlarge the opening to insert the pins. I carefully drilled out the opening to a slightly larger size so the crimped end of the pin terminal would clear the inside diameter of the plastic Molex. These Molex connectors were a challenge to use. The Molex connectors from the past from Radio Shack never gave me this much grief !

Hard to tell from the picture and description but connectors are for small18 or 20 gauge wires. Plug width is only 3/8". So double check before buying. Other than that the packaged shipped quickly and price was fine.

These connectors are easy to assemble and use. They are well made and mate well providing secure connections.

they were too small for what i needed them for but thats my fault. they are just over about a half inch in diameter so if thats the size your looking for then cool

I bought these thinking they would be compatible with a trail tech fan controller and harness, however they are too small. Hope this helps someone looking to do the same thing.