Siless Black 50 mil 52 sqft Sound Deadening mat - Sound Deadener Mat - Car Sound Dampening Material - Sound dampener - Sound deadening Material Sound Insulation - Car Sound deadening

I purchased this product hoping to fix the tinny sounding doors on my classic Dodge Truck. I was worried that it would not stick or would be hard to use. My worries were baseless. The panels are easy to cut and apply. They stick and seal well. They also cut down on the road noise and help with tinny noise. About half the cost of buying“Boom May” locally. Will purchase again!!!

easy to use and is very effective.

Update 12-10-23 ok so for some odd reason we are having some issues this year with rats in general. Likely all of the construction in the area not really clear. This is the first time since I moved in 8 years ago. That said I have to absolutely commend this product. It literally saved my ZL1 wiring. I used it for noise and noticed some trash and such in the cowl of the car. I opened it all up and found they had chewed up some junk and tried to get through the mat and they failed!!! I'm so pleased that they only chewed up the mat only a little bit but it absolutely protected any access point to wires or the interior. It took me a couple of hours to check the entire car over and really only the spots where the mat was laid were touched. I don't know if they ended up getting hurt by the metal in the mat(don't care either) but I am so very relieved no damage was done. I can easily replace the one small section. Last photo loaded. Again I realize I did not use this product for the intended purpose. I am however going to buy the new one with 3 layers for another car. Highly recommend. Easy to work with for sure. Not overly thick. For my application it did not deaden the noise as much as I had hoped. I used it within the cowl of my ZL1 to try and limit the noise from the supercharger lid spacer. I know not really intended purpose but compared to some of the other stuff out there it was worth a try and it is not obnoxious silver. Since I was able to get it into many of th bends it was easy to work with using just sissiors remove backing and lay it down. Personally I bought way to much so I will use it on other applications at some point. Pay attention to the into cost which is why I ended up with so much. 😂

I bought a roll of this 50mil VIBRO deadener to put down as the first layer. Then second layer was the 157mil closed cell foam for additional noise and heat insulation.Done to my 2006 Silverado extended cab. It had little to no insulation from the factory. I removed all the interiror carpet, console, seats, door panels, rear seat area panel, roof panel. So I had a nice empty truck. Floors and rear wall were easy once everything was out. Roof got only the 157mil foam. Doors got both but were painful to do.The end result was well worth the effort. Road noise is mostly gone. Stereo sounds significantly better. Resonance from my exhaust system is reduced quite a bit. We'll see about needing less AC in the summer. Winter cold it is easy to heat and retains it well.I spent about $150 between both layers of material and I'm very happy with the Siless products. Used some isopropyl alcohol to preclean then a hair dryer to preheat the areas before putting material down. Used a small roller to help with install. Get a small interior parts removal kit to get panels and their fasteners out. It's easier and you'll break less stuff.

Great product, easy to install and helped with the noise and the heat in our Ram pro master van

Fast shiitake amazing product

Just know that the reason this product is so inexpensive per sq. ft. is that it is pretty thin. (50 mil)If you're looking for typical "Boom Mat" or "Dyna-mat", that is thicker.But, that said, this stuff is great. I prefer it to over the Amazon Basics stuff (which is thicker, and harder to roll). Because it's so thin, it's easy to do large areas, slap it on and roll it, and you're good. I didn't even need to use a heat gun, but you SHOULD if you are applying this in a very cold place.Definitely great value for the money. The smell is pretty minimal also.

Very easy to use. Just cut to size and press. It knock quite a lot of noise down in my Ford Focus