MUFFLER LIFAN MINI TRAIL FOR HONDA 70 CT70 CT EXHAUST EX18

---before I review the part, I have to review the EXCELLENT seller: The package was held by my local post office because of insufficient postage. I went to pick up because I needed this bike done for an event. It cost an additional $29 when I got there, I just paid it and chalked it up to a loss. I did message the seller the next day. They apologized and immediately refunded that amount when I sent photo proof of the discrepancy. It's far better than I expected in this situation. They are top notch and I seek out parts I need from them before anyone else now.If you just need something to get by, this is completely ok.The bend at the head has 5-6 kinks in it, nowhere near smooth, and the radius is much wider than the stock CT70 pipe. The crash guards would not fit on my CT70k0. Sticks out quite wide at the back end.Luckily, the exhaust I needed to replace was rusted after the bends, so I cut this one up, welded it to the stock head pipe, and chopped off the rear mount and welded a stock Honda one on. With all that, it fits perfect. If you just need a pipe and muffler this is your only choice. If you don't want to pay for a NOS Honda part, like me, but want a clean fit, better be passable at metal fab.But as I said earlier, lots of sellers off this exhaust. If it still is good enough, buy from these guys over anyone else!! I give the part a 2.5 star review but because of the actions of these guys, I can't give them a bad mark, they did better than anyone else I've dealt with, hence the 5 stars.

Looks good but didn't come with a baffle my bike sounds like a dirtbike now

Fit good,looks good,all is good.

Factory exhaust was trashed. This fit close to stock. Had to modify one bracket to get this to work. It now sticks out slightly farther than factory and sort of in way of kick start, but still works.

Fit perfectly easy to install once old exhaust was out!

Bought this because it says performance CT70 . The non removable baffle is only 1/2inch (smaller than factory ct70) and did no seal on the head properly and non of the stock skid plates fit .

Muffler will fit, but missing the middle bolt secure point that was on the original muffler. You will need to modify the pipe to fit with the crash bar where the pipe comes down from the head, the screws do not have locktite on them and will back out when ridding. Overall not a $150.00 direct replacement but works just fine for the price.

Fit perfect. Sticks out a little farther that the original but other than that no complaints. This bike is over 30 years old and runs like a champ.