AN8 Inline Fuel Filter E85 Ethanol With 100 Micron Stainless steel element

Bought it to use until a name brand one I wanted came in stock. However seeing the quality of it and everything I decided to use it instead of the other option. Would definitely buy again.

Purchased this in -8 an in /out for my dual fuel pump feed to my fuel rails. Used a genuine aeromotive 10 micron fuel filter and it works fantastic. I did drill out the outlet hole on the inside of the filter housing so it matched the inner diameter of the -8 an fitting so it wasn't a restriction. Make sure to grease the o rings when installing the filter so when you tighten it up , it doesn't pinch or damage the o rings.

I ended up replacing the Filter with an Aeromotive 12650 filter($60) because the filter that comes with it does not hold well to E85 the glue used to hold the filter failed after 24hrs on E85. The fittings that come with it are a little on the small side on the ID but I was able to drill them out to the right size. Other than what was mentioned above it works well and is leak-free thus far!

Works great for E-85

I purchased an Aeromotive filter like everyone was speaking on and it still didn’t work out. After 500 miles filter started to come apart, The housing is trash. Luckily I was upgrading fuel pumps and went to change my filter and caught it in time. Yall be careful buying this cheap junk.

Nothing to dislike . Liked it's a stainless steel filter i run e85

It’s filters good

Blew a hole through the filter. Running a walbro 450lph pump. Sent all that plastic into my injectors.

Cheesy mount