Deliver to EGYPT
IFor best experience Get the App
Favordrory20PCS 1/8 Inch M3 Stainless Steel Wire Rope Cable Clip Clamp
T**M
Holding Mason Jar Solar Powered LED Lights in place on the line
I bought these to hold Mason Jar Solar Powered LED Lights in place on a line hanging over an outdoor dining table. The jars were originally hung on the line without these Cable Clamps, but were slowly sliding to the middle of the line as time passed by and the wind blew them around a bit. So, after much researching, I found these Stainless Steel Cable Clamps and installed them to hold the lights in place.Installation was a bit tricky as the hex nuts are kind of small. However, with a little patience, I was able to hang all 11 lights in place and they do not appear to have down the line to the middle at all - not even a little bit. I'm very pleased with these clamps and I know they will last a long time because they are stainless steel.I give this product 4.5/5 stars. I'm deducting .5 stars because it was a little tough to install the clamps on the wire and I nearly lost a couple of the hex nuts as a result. However, now that they are in place, I'm extremely happy with them otherwise and definitely recommend them. Just be careful that you don't lose your (hex) nuts *wink wink* during installation ;)
N**O
Not enough thread to accept coated 1/8 wire and it seems to be too small for 1/8
Does not fit on detolf shelves don't buy this!!!
M**F
Absolutely terrible
I rarely have written a bad review but this is so frustrating. The nuts don’t fit a standard or metric socket. A touch too big for a 6mm and a touch too small for a 7mm. It makes it so difficult to get it tight. F this. I see everyone else has the same issues but gives it a 2 or 3 star. Why?! Lol. It’s nearly impossible to use right.
N**D
odd size nuts
The nuts are larger than 6 mm but smaller than 7 mm using 6 pt sockets. Nuts are too large for 1/4" but a 9.32 6 pt socket slips around the corners. Makes the clamps all but impossible to use.
B**N
Nice, but actually M4 size
These worked very well for my application (12volt pendant light fixtures), but note that they are not M3 size, but actually M4. This might save you a headache if you need to source additional nuts like I did.
P**N
Quality clamps
These appear to be very good quality clamps-of course, time and use will tell but they appear very well made. Prompt delivery and would buy again if needed.
B**E
Not enough thread to accept coated 1/8 wire
These are great quality stainless but the ones I received had very short threaded length on the U-Bolts. So short that I could not threat my coated 1/8 steel wire through when fully opened. Had to return.
E**.
Small size but good product
Be aware they are small. i really needed bigger size but did not pay attention to desciption
Trustpilot
3 days ago
1 month ago