3DLAC 3D Printing 3D Printer Adhesive for Adhesion to Heated Print Bed, Spray, 400 ml 13.52 fl oz

Absolutely love this product. My brother runs a 3d print shop and recommended this to me when I got mine. I was so sick of scrubbing glue off of plates that this product feels like a lifesaver. It works extraordinarily well, keeping pieces secure on the plate with no warping. Very easy release, and it leaves the bottoms of the piece looking perfectly clean. I've been spraying it about every three prints. but I'm sure it could go longer without issues. I've only used it with PLA so far. I believe that it is worth the price, although I haven't determined how long it lasts yet. I also think it smells really good. My only nitpick is that the nozzle could use a little more control.

Definitely has a smell to it but it works great, and none of the artifacts in the prints you can sometimes get from thicker glues. A little bit goes along way on smooth PEI plates.

literally the best adhesion spray ever. easy to clean off, no smell. prints come out immaculate every single time!

Much better than glue sticks. Also tames an unruly beard.

Absolutely love this product. I was using glue sticks for better bed adhesion but had to wash my plates after a few prints to avoid too much build up and would leave the prints sticky. This creates great adhesion without a sticky residue. When you let the prints cool a bit before removing they come off super easily. If they cool completely they practically slide off. Also love the fact I can spray a light coat on the build plate, let it dry for a minute or two and start a print up.

Works perfectly. Only one thin sprayed layer and my prints stop to detach from the bed.

This stuff is fantastic on a textured PEI plate - the standard plates on both my Anycubic Kobras and my Bambu H2D. It is a little less effective on the smooth patterned plate with the holographic effect, but that's okay really. I use a different formula for those that works quite well. It does not leave a sticky residue on the plate, although sometimes afterwards I can feel it a little on the print. It easily cleans up with warm water or rubbing alcohol. I've used it with PLA, PETG, PA-CF (nylon carbon fiber), ABS, and ASA, all with success. the latter three were in the closed environment of the H2D. I will probably purchase it again when the bottle is gone, but it is lasting a long time. Does not really need to be applied every single time, maybe every other or third print. I also don't wash it off each time either and it hasn't really built up or anything.

Works great large volume not much needed per use