Rough CountryFront Track Bar Bracket for 2007-2018 Wrangler JK | 3.5-4" - 1118

Super easy install and super strong. Should be considerably stronger than stock with the additional U bolt and extra bolt on the spring perch. I also like that it flips the steering stabilizer to the top.Only hard part to figure out before buying was if it fits a Dana 44. The AI response was it only fit the 30. I had to dig around on the RC website to confirm it for my Rubicon Dana 44. But it all bolted up great!

this installed easy and fit perfect, i originally ordered the JKS bracket but the holes didn't line up like most of the reviews already said this RC one lined right up and went right on with no issues. i paired this with the top bracket from Synergy which also had no issues at all.

Very strong, easy install, not the highest mount on the market but overall a very good choice

OK, Lets start by saying my Jeep is built entirely of RC products. This was not an intentional thing, it just worked out that way.This bracket is a nice piece. It does actually move the axle closer to center but didnt exactly center it for me. Its close but just not quite there. Over all, they are a nice, thick piece of steel, powder coated to prevent rusting. Mine have been on for about 10 months and holding up just fine.

Quality piece , works as described.

This product with the rough country draglink flip kit Made My Jeep drive better than the day I bought it. I bought this Jeep and somebody put a lift on it and did nothing else. They put a track bar bracket in the rear of it and and put it in the lowest hole and I moved it up after I had everything done in front and I took it for a ride and it was day and night. I could drive that thing with my thumb and my index finger on the steering wheel and my arm sitting on the armrest going down the road at 70 mph !!! Large improvement. I still need to put the rough country adjustable lower control arms on it and adjust the caster to where it needs to be and it will drive like a freaking Challenger !!!

My 2007 JKU Jeep with 4” Lift had trouble with bump steer due to the drag link being at too much of an angle. This corrected the problem completely!

I had bought and installed a pitman arm drop and had very bad bump steer. I didn't know at the time when you do a pitman arm drop or drag link flip you had to correct the track bar with it so after installing the bracket it corrected the geometry. The drag link and track bar needs to stay parallel.