Boss PCS-20A Parallel DC Daisy-Chain Cable

I own two BOSS footpedals (TU-3 Tuner and BD-2 Blues Driver) with this cord they are linked with the optional power supply supplying the power to both. This eliminates the need for batteries and I have growing room for more pedals to be linked in the future. I just zip tied the extras to get then out of the way until needed. Don't know how it would work with other brands of pedals, but for BOSS it works great!

In church I use a simple acoustic setup, a Boss TU-3W Tuner into a TC Electronics BodyRez then finally into a Fishman ToneDEQ, which gets plugged into a cheap Bugera AC60 amp. To keep the spaghetti mess of wires down I almost bought a power brick which of course is efficient and all that, but this uber-expensive awesome tuner has a power-out jack and can push 500mw. A great solution would simply be to power the TC and Fishman off that, but you would not believe how impossible it was to find an answer! So many reviews claimed this power cable ONLY worked with Boss pedals, yadda yadda yadda. Finally I called a place where the water is sweet and asked if the Boss Waza mega tuner could power the other two pedals, and he did something for me that was super helpful: he looked up the power draw for all 3 pedals, and also confirmed that the non-Boss were negative-tip. In 30 seconds I had my answer: Boss draws 60 on normal setting and 100 on bright; TC draws 100mw and the Fishman draws 200mw. Total 400mw, so there was no reason why this adapter cable wouldn't power the non-Boss pedals from the TU-3W tuner (which of course is running on the Boss PSA-120S power adapter). Well, HE WAS RIGHT, I got this cable, hooked it up, all three pedals worked great while playing in the service yesterday. The documentation for all these pedals almost panics that you must only use their approved power adapter, etc etc, but as long as you research how much draw there is, you should be fine. This adapter cable simply has 8 female power plugs, so one went into the TU-3W power output jack, and then I hooked up the other two pedals. You don't have to hook up the cable in order, the whole string is serial... I have the #2 plug in the TC and just used #7 or 8 for the Fishman. It is SO nice running the one thin Boss pwer cable to the tuner then chaining the other two. Now that it's confirmed it all works, time to build the pedalboard! (I'm using the Emerson 18x7).

Excelente producto

This daisy chain worked awesome with my boss Tu-3. Not an iso power supply so it def had some noise with a couple of my non boss pedals, but it powers as intended

Powered off my Boss Tu tuner this cord is quiet and functional. Running TU2, BD2, Ibanez TS9, Ch1 and DD3 nice and neat and no expensive 9v batteries needed!

This is pretty handy when your short on electrical outlets. It also usually only works with Boss pedals. I have a few other pedals that it will power, but most of my non-Boss pedals are different sizes. It's still a good purchase; however, it has allowed Boss to monopolize my setup.

Power what it is supposed to! Worked perfectly right out of the package.

What worked as expected: I connected this chain out of a Boss TU-2 powered by a Roland power adapter. The chain powered the Boss GT-1, Ph-1R, and RC-2 just fine and was NOT at consumption capacity. What did not worked as expected: The noise interference added by the chain affected the sound negatively. I spent considerable time with different positioning configurations and found the noise was present only while using the daisy chain as described above. Noise was not present when powering the pedals with a dedicated power adapter.