🔧 Elevate Your Craft with Precision!
The uxcell 5PCS 1/8" Shank Carbide End Mill CNC Router Bits are engineered for precision and versatility, making them ideal for cutting, engraving, and milling a wide range of materials including acrylic, PVC, and wood. With a durable tungsten carbide construction, these bits offer high wear resistance and can operate at higher speeds than traditional high-speed steel. The spiral design ensures efficient chip removal, while the chamfered shank enhances usability, making these bits a must-have for any serious craftsman.
M**N
Great Little Cutters
These worked great for my CNC project, and cut cast plexiglass fantastically. The tiny diameter means you may break a bit or two, but that's why you buy a pack of 5!
S**M
Two flutes, up-cut, worked well.
Two flutes up-cut. Worked well with no issues. The cutting length is reasonable, which helps to not snap them off so easily, like the ones with the crazy long spiral cutters. Would buy again.
N**P
Perfect.
Used it to carve out a groof to fit a floral hoop on about 20 wood rounds. Still sharp and sturdy.
G**G
Actually surprised they are pretty good.
I ran crazy slow feeds and it survived 2.5 hours cutting 6061 aluminum first try without breaking one. Went all the way down to 6mm.4200rpm 2.5ipm I think it was about 0.0003 fpt 0.04 docMake sure you have a good spindle with no runout, accurate machine and LOTS of patience. Sometimes just getting the job done is more important than speed.
A**R
Amazing quality for price!!!
So far have only used on White Pine for projects, however, for the price I've been able to run this bit at faster than expected feed rates. Still haven't found the limit for how high of a feed rate I can reach before the bit either burns out or breaks.Truly recommend!!!
B**N
works if you don't take too deep a cut
I use these to cut letters into wood. Works ok if you take small incremental cuts, will eventually dull but works fine if you don't cut too deep. I use 0.006 inches per cut at 10 inches or less per minute.
O**5
BUY THEM
These bits are well worth the money. I have only used them on MDF and i am extremely pleased on how clean of a cut they give.Will purchase again.
J**T
Single flute Dremel bit
Works good on clear acrylic sheets and PVC
M**.
Buenas fresas, aunque frágiles
Las fresas cortan muy bien. Se pueden hacer trabajos muy precisos con ellas.Ajustar bien los parámetros de vuestras máquinas, porque al ser tan finas y largas, es muy fácil romperlas.
A**E
Really Impressed with these bits
These are smallest bits I've bought since getting my 3018 cnc. To be honest I wasn't expecting too much from them but needed some fine detail in a project.I'm still on the first bit a few projects in and cant complain engraving 12mm birch plywoodGreat bit's for the money
D**A
It doesn't feel like tough carbide.
Nice blade on look but when using them for cutting they brake. I still have several left it could be my inadequate speed or rotation but they just feel weak for now.
T**N
A great detailing bit
I bought this pack of 5 and after a few weeks of use, I still have 5. This is rare as these small bits normally break easily when routing hardwoods but I've had no issues on maple or oak.
S**T
bon
bon
Trustpilot
1 month ago
3 weeks ago
