15229012 ABS Wheel Speed Sensor Front Left or Right compatible with Cadillac Escalade Chevy Avalanche Silverado 1500 Suburban 1500 Tahoe GMC Sierra 1500 Yukon Yukon XL 22740468, SU9451, 5S7985, ALS146

2012 silverado LT perfect fit including the mounting clips in the correct spot to affix to body. No Issues. Fixed my issue of ABS and Traction control lights on (due to severed wire) on dashboard. Perfect comparability. Thanks !

Great oem replacement

Perfect fit, came with everything needed for an easy install .

If the old sensor breaks at the axle use little bit smaller drill bit to drill into it and the rest of the sensor will pull right out

Part was almost identical to the original. The only difference I could see was the O-ring that seals the sensor to the axle is a different size making a very tight fit. You will most likely have to do a little work to clean out the hole very well (rust and debris collects here over time) and lubricate the O-ring and hole with a little silicone grease and then carefully turn and push the sensor into place being careful not to damage the O-ring. Original O-ring is a little more forgiving, but it is a different size so you can't reuse it on this new sensor. Great price!! I hope it lasts as long as the original.

Fast delivery and high quality. Fixed my abs codes..

I am very happy with my purchase, the normal cost for this is much higher than this less expensive one and they both work the exact same. Packaging: The product came well packaged and the label on the bag showed that it had not been tampered with. Everything was there and the make and model of vehicles it fits was also represented on the bag. Quality: This product is made of good quality material. The wires are adequately covered with rubber and the connectors have no issue connecting to the vehicle. Installation: Parts Needed: New Sensor 18mm, 22mm socket and ratchet T55 Torx Bit 5mm Allen Bit Needle Nose Pliers C-clamp (Large) Torque Wrench Jack and stand Flat Head Screwdriver Process: 1. Remove Tire: Loosen lugnuts while it is on the ground and then remove lug nuts after its on the jack Remove hub cap Remove wheel 2. Remove T55 Torx Bolts on the back of the brake caliper 3. Remove Brake Pads Use a Large C-Clamp Place it on the bottom of caliper to press in the piston allowing for easier removal of the brake pads Use flat head screwdriver to remove pads 4. Remove Caliper Remove the 2 18mm bolts from caliper bracket Remove the bracket 5. Slide the rotor off 6. Remove Sensor Remove the 5 mm Allen bolt Using the flathead screwdriver pry up on the sensor Once the sensor is free press it through the backing plate and out Use needle nose pliers to removed the clips to release the abs sensor 7. Install the new sensor Connect the harness Place the bracket and feed the sensor back down into place Realign and screw in the 5mm Allen bolt Place the rotor back in place with one lug nut to hold it Turn the wheel and put the caliper back into place Replace the two 18mm bolts Torque both to 75-foot pounds Place brake pads back into place Place caliper back on Grease caliper bolts and slide the slide bolts back in Torque both to 30-foot pounds Replace wheel and replace lug nuts Place car back on the ground and tighten the lugnuts Replace the cap and tighten BE SURE TO FOLLOW THELAST STEP BELOW! Once completed pump the brakes until the pedal tightens Then do a stop test from 5mp and then 10 mph Overall, this was simple to install took a total of about 15 min and my ABS light is off in my vehicle. The only thing I would caution is to ensure that you have the proper part, and if you don’t have extra clips for the sensor to hold it in place take care in removing the old sensor, the clips tend to break easily.

Yes the sensor we ordered was what we wanted and worked out perfectly

Replaced both rear ABS sensors in 2008 Sierra. Cleared codes and no issues. Similar quality. to factory units that were in. Good bang for my buck.

Fit was perfect and took abs light off of dash

Worked great no issues have put 5000kms on since install

Arrived quickly. Took a bit of time to get the old one out but when the new part was installed, no more code issues! I going to remain positive considering some of the reviews, but let’s see how long the part will last.

2007 silverado 1500. Fit great. Comes with clips installed