ValvolineCVT Full Synthetic Continuously Variable Transmission Fluid 1 QT

I have used this in my 2015 Honda Accord LX with a CVT transmission for several months. It is cheaper than the Honda HCF-2 fluid and I have not noticed any difference in the performance. It may be even better than HCF-2 fluid since it meets several companies CVT fluid specifications.

2013 Altima 3.5 owner here. Wife is the primary driver in the central FL stop-and-go traffic and the oppressive heat/humidity (the humidity also reduces the effectiveness of a heat exchanger....and this makes Florida worse than even Texas or Arizona for heat related failures). Wife does most of the driving. She had her first violent "CVT shudder" at 27,000 miles and, now at 28-and-change, the transmission is beginning to behave poorly. It's slow to change ratios, allows more vibration through the driveline, and is sluggish off the line. Nissan dealers at first refused to change the fluid as it was a "60,000 mile change interval. It's FINE." Then they agreed to change it with the newer (and thinner) NS-3 rated CVT fluid....for $330 for a drain and refill. This was the same price at two different dealers in a major Florida city. Unacceptable.So I conducted my due diligence research and found this Valvoline CVT fluid, which their latest data sheet (available on their website) indicates is compatible with the NS-3 standard.So I drove my Altima up onto a set of ramps, finagled the drain plug tube stopper (with NO DIPSTICK attached, mind you) off of the drain tube, and obtained a drain tub that has markings for fill level...so I could quickly and easily measure EXACTLY how much fluid came out. Good thing I did, because according to most folks, 6 quarts were going to exit my transmission....but only 3 quarts took the dive due to the incline of the vehicle. No biggie. It'll just take two drain and fills to use up my 6qt case. Please remember that this transmission will throw a code AND go into a full-on limp mode (crippling the car and preventing you from shifting into drive in some cases) if there is too little fluid, OR too much. So getting within about a tenth of a quart is important. Also, double up your gloves because the fluid needs to be at operating temp to be drained and this is HOT.Onto driving impressions with only 3 quarts swapped: The transmission is observably quieter, smoother, and more responsive within the first mile. Within ten miles, the difference is stark....it's back to the ultra-smoothness that sold me on the car. I'm very pleased! I'm excited to do another 3qt drain and fill this weekend and am expecting more of an improvement. In fact, at this level of economy via Amazon's great prices, I'm debating an additional drain and refill with another 6qt case just to have more of this fluid in the transmission, period.Note: this Valvoline fluid has a very light green tint to it. Not nearly as green as the factory NS-3 Nissan fluid...but at least it's not red. I do not think a dealer would even notice that another fluid has been used. It looks very close to the NS-3 fluid when new, with less green dye.Lastly, the factory fluid that came out was dark green, looked burnt, and had a burnt smell to it. It was very clearly at the end of its useful life. Having smelled a freshly opened quart of NS-3 Nissan fluid at the dealer, the factory fluid is DONE at 28k miles. It seems Nissan should be observing 20k fluid change intervals for their CVTs as my wife drives the car very easy and always lets all fluids get to operating temperature before giving it the beans in traffic. This Valvoline has a full synthetic base stock and is designed for high-temp applications. I'm very pleased so far and buy with confidence for your NS-3 compatible Altima, Maxima, or Pathfinder CVT! Go Amazon!!!A note for the 5th gen Altima: The CVT in this Altima has a circuit from the engine coolant outlet on the radiator that passes heated engine coolant directly to the transmission to speed-up the transmission warm-up and to thin the fluid so it is functioning in its most optimal range. So, while this fluid is certainly thicker than the factory fluid in cold climates, using the Nissan engine freeze plug block heater when it's cold would ALSO serve to warm this tranny up much quicker. Not a concern for me in Florida as I only see temps below 20 degrees F once or twice a year. Any Nissan dealer can install this freeze plug and there are several to choose from here on Amazon for about $40.MPG Note: My wife has seen her long term MPG creep up by .1 MPG this week. Could be weather. Could be statistical noise. But she also reports easier cruising with smaller throttle openings. Regardless, there seems to be no negative effect on fuel mileage.

I recently serviced the CVT in my 2015 Jeep Compass. I did a drain and fill and also replaced the two CVT filters. This Valvoline 6-pack was the perfect amount, and I had a quart extra for topping off and future use. I recently did a 9 hour drive from Kansas to New Mexico. I used Jscan to check my CVT temperature when I got to my destination and it was running at 153*. So far, this fluid has worked very well in my Jeep and I'm happy with it. This case of 6 came out to less than $10 a bottle, so it was the best price I could find.

I used this in my 2020 Mitsubishi Mirage, so I figured I'd let people know how it went in case they have a Mirage too and are considering buying this. It works perfectly. The transmission operates as smooth as can be. So if you're concerned about getting this instead of the Mitsubishi brand fluid, don't be.

I could immediately feel the difference when I performed the cvt flush and replaced the filter and drip pan. The car pulls strongly and I feel assured that the fluid is doing its job.Definitely great value for money and the gear chifts are smooth. Valvoline is a quality brand and I definitely will use this fluid again.

Truthfully, I've noticed no difference. At 100K miles I thought that it'd be a good idea to change it anyway. We've never abused the transmission so the oil that was drained didn't look "off". Trans seems to operate like it always has so all is good. I've used Valvoline motor oil exclusively and have had zero engine problems. No reason not to trust this.My only complaint is that this is some evil smelling stuff. If it wasn't synthetic, I'd say it was made from some pretty sick dinos.

I put five new bottles of this stuff through my transmission after draining the pan. Shifted through the gears slowly while the vehicle ran on jack stands. Then I drained that out and put in another 5.5 quarts to top the system off. My 2014 Subaru Forester with 114k miles operates smoothly after doing this. It helped the old fluid out a bit, I can feel a slight difference and it's better now. I will probably change out another 6 quarts in the somewhat near future to just start a routine of keeping fresh CVT fluid in there to ensure the transmission stays alive as long as possible. I used to use this same fluid on my Nissan Sentra with the same process and we never had problems with the transmission. I sold that car at 160k and it still ran like new.

Unfortunately, my year Altima did not have a drain plug, so I had to remove the pan. I realize that this doesn't remove all the fluid, but it does remove the same amount that most dealerships are taking out. My Altima had dealership fluid exchanges at 60000 and 120000 miles.nnthey are expensive. This time, when I got to 160000miles, I decided to drain and fill. I removed both filters, including the small cartridge filter that is a PIA. Fortunately, I'll likely never replace that one again. So far, about 2000 miles later, everything seems to be working very well. This fluid is clear in color and closely resembles the factory Nissan CVT fluid, which I think is made by Idemsu. Do not use the Valvoline in the red bottle because that fluid is red and may confuse things in the future. Stuck with this synthetic blue bottle fluid. Stinks bad but works great, so far