Lower Control Arm Cam Bolts for 2005-2021 Frontier - 1004

I've had these on for over a year now and have no issues at all. If you do not know how to use bolts with only one cam lobe please do not buy these. Not rocket science. Works the same way as two cam lobes, but with one. No matter which ones you choose use graphite based antiseize because copper based will still corrode in salty conditions. You'll know what i mean when you have to cut out those factory lca's. (7 inch grinder hint hint)

Quick shipping and excellent service

These bolts do not include the offset spacer for the front end of the bolt nor are the bolts keyed for a front spacer. I took my truck to 2 different off road alignment shops that told me they could not adjust it because it was missing those pieces. I have now had to pay for a partial alignment that could not be completed because of these parts that are not included in this product. I am using Bilstein 5100 shocks to add an extra 2 inches to the front of my 2015 Nissan Frontier so I do not think I am exceeding the expectations of this product.

Will work when pinching pennies but if you care about your alignment long term, get something with offset washers on both sides. Only one washer is offset, with 2 tac welds barely holding on, the other washer will try to "walk" over the stops since it only sits center on the bolt.

The LCA lower control bolts are not cheap any place I looked. They were a bit hard to find but the rough country "cam bolt kit" was good. It is all 4 cam bolts you need (pre painted) with all hardware for your 2 lower control arms.

Bolts work as expected and super fast shipping. Would purchase from seller again. They are shipped 4 per box (2 sets) and not 2 as shown in photo. Ordered 2 to ensure I have for both sides, but to my surprise I end up with 8 bolts total. Hope they update description and approve my refund.

What the title says. Added this to my 2.5” level kit.

there is only a cam on 1 side of the bolt so when you are turning to move the control arm the cam goes over the plate it is pushing against or bends it. it also pushes the control arm bushing crooked in the arm. i would not buy again, get ones with cams on both ends.