VonHaus Benchtop Belt & Disc Sander, 100mm x 915mm, with Cast Iron Base and Integrated Dust Port - Removable Table, Sanding Belt and Disc Included

no complaints. Sturdy, decent power, capable of heavy sanding and after adjustments, sanding for fine modelling work. Given the price, very impressed

I have used this for three years, maybe a few times a month. It has worked fine. The sanding belt is easy to adjust. To change the belt (eg from 80 grit to 240 grit) you loosen a hex bolt to tip the belt carrier upright, and remove two screws to take off a dust shield. Then pull a lever to slacken the sanding belt, remove and replace and put everything back. Couple of minutes job. I don't bother retightening the hex bolt as gravity holds the belt carrier down, and have not had an issue with this in 3 years.For 3 years I have put up with the horrible noise this machine made -- a scraping, banging sounds from inside the casing. I assumed a badly aligned part and this was the price to pay for a cheap sander. But today the noise got much worse, so I was forced to take the machine apart. One of the pulleys for the drive belt had come loose, and the belt and pulley were rubbing on the casing -- causing the noise. But on further looking, I could see that the pulley had been put on the wrong way round (at the factory I guess). This caused the belt and pulley to stick out more, and this had given me 3 years of annoying noise. Put the pulley back correctly, and now the machine is quiet.It seems very solidly built. After 3 years the drive belt is not worn, and the sander still works perfectly.I would have given it 5 stars, but deducted one for poor factory quality inspection.If it breaks down, I would buy another of the same make.

THE SANDER came was very well packed it would be very difficult to damage. The sander itself is well built and powerful enough for all but heavy duty commercial jobs. For most DIY you would be hard pressed to get better especially at the price. It after all is a DIY product not commercial. Great machine very happy.

Works really well and using a dust extractor on the main belt gets rid of most dust

Seems to be a quality piece of kit . I use it when making hiking staffs/walking sticks, bird boxes. Sanding belt easy to change and aline

This is a great little bench top sander for the casual DIY'er, not a bad price, but would have liked it to feel like it was a little more of a 'quality' item. Personally I'm not feeling the placement of the on / off buttons are well thought out, with the belt sander set vertically and facing you, the power buttons are at the rear right hand side of the machine, so you have to reach around to turn it on and off which means your hand etc will be passing the circular disk part of the sander that runs whenever the machine is on...feels like I'm going to catch my hand, wrist or sleeve on it at some point. :-(

Brilliant, that’s all I can say, specially for the price😁👍

Just what I needed, saves me a ton of time, perfect buy.