Performance Tool W141 2-Jaw Gear Puller, 6

Tool was to big for what I needed. But if the legs would have been the same length it may have done the job. Pulled on a angle and would slip off, even with a clamp restricting the jaws from opening.

Don't expect to pull anything over a few inches with this. The finish has held up really well for the amount of abuse it's taken, but the long flats that sit behind the gear have bent over time, and it tends to slip off of whatever you're pulling unless you hold the flats together. Much better than a screwdriver or a hammer, but not an end all be all.

Couldn't stay attached to the wiper blade. Unable to remove it with this tool

great value

I hoped this would help remove the wiper arms from my car. Seemed like it might be enough for such light work, but no … the arms bowed inward on the first try, and it slipped off. Went from there straight to the trash can, and i went to harbor freight.

Needed a gear puller for a mower blade adapter. Economical. Simple to use. Did the job.

Works just fine for gears and bearings that aren't stuck but just have little clearance to get other gear puller jaws in.If the bearing or gear is stuck at all, however, the jaws will bend quickly and permanently. This is a case of getting what you pay for.

Needed to remove a pulley - did the job. What more can I say? This was chosen on the basis of price, so quality was not a real concern -- certainly found it serviceable, but can't really speak to durability. I don't know if I will ever use it again, but couldn't figure out how else to get the pulley off, after drilling out the set screw.

This didn’t do the job. Bent the jaws and handle. Might work ok on lighter work

The main screw is just tapped through sheet metal that is way too thin. The threads skip at the slightest application of force. Absolutely useless, this product shouldn’t exist. You’re better off attempting to pull whatever you’re pulling with your bare hands.