Longruner 7 Inch Monitor Touch Screen Case for Raspberry Pi 3 2 Model B and RPi 1 B + A BB Black PC Various Systems LSC7B-1

Does the job but there were no instructions to assemble luckily I’m quite handy with diy but someone who finds it difficult would be scratching their head wondering how and where to start. Also if the screws where to be flush with the acrylic when screwed in and possibly black would be a good look. Other than that for now does the job for my pc sensor panel

OK, I'll start by addressing the complaints that this item is 'not the right color' or 'made from the back of a dresser'. It is black, just like in the pictures. The parts are covered with a brown paper protective film which peels off.It took me about ten minutes to assemble. The feet brackets can be put on two ways - so the stand sits with the bottom edge flush with the table top, or slightly higher with a gap under the bottom edge. I have a Pi 400, and assembling the feet so there is a gap under the screen allows all the USB and HDMI cables to neatly pass under the monitor.Like one other reviewer, I did notice that the ribbon cable for my Elecrow 7" LCD touched the frame because the cutout was a little too small. Ten seconds with a file fixed that.It does what it was supposed to do - holds my 7" touchscreen. It wasn't expensive and it works. It's not particularly pretty, but I'm usually looking at the screen not the surround.

Received unpainted, not even in a base primer, just actual materials cut from the factory, no finish at all. Expecting to be black I returned it and ordered another one, arrived exactly the same, returned it, ordered a different brand.If it had been painted, it would've been perfect.

I have a 7” Elecrow 1024x600 touchscreen display and couldn't find a case for it. Just before breaking out the plastic sheet and hacking something up I had one more look and found this. The physical dimensions and interface placings are exactly the same. In fact it would be hard to argue that they are not made by the same manufacturer. The case/stand is great and only takes a few minutes to assemble around the display.

The 7 inch screen shown in the item pictures looks very similar to my display, yet the item does not fit. The hole is not big enough to get the screen through and would need considerable modification to make it fit.The item is also quite brittle, just pushing it a little to see if I could tempt the screen in and it snapped in 2 places!I would advise you look elsewhere and to avoid this item

Purchased this as Amazon promoted it as "frequently sold together" with the 7" touch screen that I bought.I don't mind assembling things myself, but this comes with absolutely no instructions and I quickly found out that it wouldn't fit easily.I filed off about 2mm on the inside to make it fit, only to find out that the screw holes don't line up with the screen and that the bolts that are supplied are not long enough.Will make this work with newly drilled holes, but this is totally doesn't fit the Jun-Saxifragelec 7 inch IPS Touch Screen

Perfect fit for the Elecrow 7" LCD screen and glad they're available on Amazon rather than having to order from abroad!Only criticism is that the small recess in the bottom right hand corner that I think is to give room for the Elecrow touch screen ribbon cable is a bit short and would still catch or put strain on part of the cable. I've extended the recess a little bit with hacksaw and sanded any sharp edges down so it's smooth. Now it's perfect!

I used this product as a frame for my 7" display in my pc, I sprayed it white to match my theme. Fit very snug around the display, for what I wanted to use it for, it was perfect for me.