Wall Control ASM-SD-008 BU Pegboard Screwdriver Holder Bracket Slotted Metal Pegboard Accessory for Wall Control Pegboard Only, Blue

the screwdriver holder does not mate well with the hanger bar. It is loose and feels wobly. I did close the two popouts a bit to tighten the connection but it did not help. The two corners are very sharp and could lead to cuts. How much would it take for them to round the corners before painting? I would not recommend this accessory. I have quite a few of their other accessories which I am happy with.

Many complain about the quality of this item. I find the corners aren't that sharp and they are fairly stable once installed in the peg board. It's an ok product. I have no major issue with it.

Most of Wall Control's products are exceptional; however, this is an exception to that for three reasons.First, the whole premise of Wall Control is to have accessories on a pegboard that will not come loose from the board. Why then did they make a support that goes onto the board, and then design the screwdriver holder to simply slide over that support. It is not a snug fit, tends to rock, and does not take much to knock it off of the support. Why on earth would they not make it as a single unit, that would fit securely to the board.Second, although it is nice that they make smaller holes on the right hand side for smaller screwdrivers and drivers fit nice and snug, this snug fit is also a problem. In order to get anything in and out of this holder, you must come straight up, you cannot lean the screwdriver into the holder, or slide it in. That means that a tremendous amount of space is needed above the holder for any long screwdrivers, therefore reducing the ability to use any open peg slots above it. This would be far more useful if at least the upper holes were slotted.Since their boards are either 16" wide, or 32" wide, you would think that this holder would be the appropriate width for their boards. What I mean by that is either make the thing 8" wide so you can put 2 next to each other, or make it 16" wide. With the way these are designed, and the problem of getting screwdrivers into it, you would use up an entire beg board for nothing except screwdrivers if you even have a basic set of 6 standard, 6 Phillips, and 5 Torx, placing one above another and having enough clearance to get the drivers in and out.Although they are pretty, I am going to trash these, or return them, and go with standard style pegboard screwdriver holders. I'll go t he the hardware store and pick up some paint to paint them first, but at least those worked well and did not waste space. With a small dab of silicone rubber where they make contact with the wall, they will never come out.

Nice fit and good for storing esp screwdrivers. Do wish the holes were just a bit larger for esp larger throated tools though the open style alternative works well. I just forget about it being available. Just remind yourself which is best. Hopefully, the manufacturer will update the description to help remind everyone of the alternative available. Do check the open style if you have esp. > 1/2 shaft electrical screwdriver to store

kind of not very well designed. Bulky. Holes are too tight.

Love it, bought their peg board to put it on. Very sturdy and secure. No movement when pulling out tools.

This device provides very efficient use of space on my Wall Control panel. This is the 2nd unit on my panel, one for Yankee and one for Phillips.

Works well for many office supplies also.

Not what I expected. Overpriced for what it is. Wall control pegboard is nice but this is more pretty than functional. I regret ordering it.

These are well made and the entire produce line is great.

Cool