BOGAR TECH DESIGNS Sidemarkers Reflectors Lamp Precut Tint Kit Compatible with and Fits Kia Stinger GT (ONLY) 2018-2021, Dark

Quality is amazing no trimming need !

The tint I received was cut to thin even with a lot of stretching. It looks terrible so I can’t use any of it and I tried contacting the company multiple times and no response so, needless to say the customer service is garbage… sad to say I’ve wasted time to try and get this to work.

These just arrived today and I put them on shortly after. They went on quick and easy. Fits perfectly on my 2019 GT1 stinger.

These turned out a bit better than I expected. Wanted something I could use to black out this section of the rear lights without permanently painting the lenses, and it definitely does the job.Most of us are probably DIY buyers, so a couple of install tips I picked up on the fly:1) Make sure you apply plenty of water with a spray bottle to both sides of the overlay, as well as the surface of the lenses while you’re applying/aligning the pieces. If you don’t lay it perfectly the first time, you can lift the overlay back up and respray until you get tue desired alignment.2) Don’t be afraid to use your hands. After I minimally scratched the first piece I placed and adhered, I switched from a felt wrap squeegee to a good ole’ elbow grease and finger strength to push the remaining bubbles out of the overlay (spraying with water often to keep the surface slick). I did still use the squeegee to push large bubbles out while getting my placement right.3) Use minimal heat. If you have a hair dryer I would almost suggest using it versus a heat gun. Again, trial and error after applying too much heat and too early. You should only need the heat after the overlay is mostly placed. Try to work out as many air bubbles as possible before using a heat source (unless you need to use heat to stretch the vinyl for fitment).4) Patience and attention to detail is key. Upon first glance, I was not satisfied with the look of these. I thought they looked rippled and too bubbly/foggy. The instructions warn of this with the same message: don’t fret. I realized within several hours that the overlay began to adhere fully. After 24 hours there were still a couple of small bubbles I wanted to work out, so I re-applied some moisture/heat and got them looking great.Overall would definitely recommend the product for the price and ease of use!

The media could not be loaded. If you don’t want to watch the video let me summarize:Side pieces as other people say; DO NOT... Fit completely. Recommend cutting off from the second sheet you get and adding that extra inch on, cutting it and shrinking it on the side.Back two light pieces are fine, won’t require stretching. BUT.. make sure you use a CLEAN. Microfiber towel or even a new one as even the smallest dust particles will create bubbles that you can’t get out.If they made they made the side pieces fit to scale, would be a 4- star. But so far for installation, not hard although... you will have to fight with it for a little bit.Update: Vendor sent me another pair to fix and update mistakes, warranted 5-star review for excellent service.

Title says 2021, picture states another year...I didn't know which one to believe. So I got these in, put one on and noticed that it isn't cut correctly. Part of the film covers the light and some of the other shows the light/lens...whatever. But what you see in the picture is the other part of the problem, its not long enough! I didn't try the other pieces because I am so upset with this one. Guess I just lost 40 dollars, time to find someone that knows what they are doing and how to measure correctly.

Everything was good except the long pieces for the side reflectors aren't long enough. They leave about an inch un covered

Works good. Fits fine. Just prone to bubbles if you’re not careful with the application.