Supershieldz (3 Pack) Designed for Garmin GPSMAP 62 62s 62st 62sc 62stc 64 64s 64st 64sc 64x 64sx 64csx 65 65s Tempered Glass Screen Protector, Anti Scratch, Bubble Free

They work great. I'm hard on equipment and have had to send units in for screen repairs. They're just never quite right after that. Twice I have struck the screen and thought for the screen protector and unit screen would be cracked. The protector cracked but did its job. Glad there is more than one to a pack. Easy to install and pretty easy to remove. They have been very resistant to scratching.

These were a good fit on my Garmin GPSMAP 65s. Not excessively wide like a few reviews mention. I wonder if all Garmin screens on this series vary a bit with the amount of chamfer. Mine could stand to be maybe a half mm smaller split between the two sides. Due to the angled sides of the screen even if it was a perfect fit, the edge of the glass protector is a bit vulnerable to chips. I ended up adding a Tusita silicone cover and that completely shields the edges of the protector anyway. The glass is crystal clear and I don't even notice it's there. It went down with not a bubble to be seen. No instructions specific to Garmin but I used one of the supplied tape tabs on each side to handle the protector after peeling the backing. Do a couple dry runs so you can eyeball it and set it perfectly. I could have done better centering it top to bottom but it set down so nicely that I didn't want to risk peeling it up and getting dust under it. Side to side placement is more important, no room for error. The Garmin screen is plastic so you really need something like this.

This is a survival tool for me. Should I ever get lost in the deep woods I have tested it under conditions of duress just see how reliable and useful it is. Its graphic aren’t great more like an old cell phone with large pixels. Other than that it is a great way to stack your own position on the globe and can be easily used with a supply of double AA batteries which I suggest you always carry with you in your pack.

Perfect fit, especially with the silicon cover.

In my opinion, these tempered glass shields are not a good fit for the Garmin GPSMAP 65s. Yes, they have the general design concept following the perimeter around the 65s's display though the edge of the shield will generally be 3-4 millimeters smaller than the display in size. From left to right, your screen will be covered (except for the beveled edge). From top to bottom, your screen will remain unprotected beyond the edges of the Shield. The area of the display that is most important and contains the data you'll be using, is protected.*Supershieldz - Install Video*The install video was developed for a thin iPhone device, not for the Garmin 65s which is much thicker. Attempting the suggested "hinge method," with tabs designed for a much smaller device, will screw things up. I removed and tossed the first of three shields provided due to the failure to provide accurate information for the Garmin 65s.I installed the second glass cover free-handed, mimicking the other instructions and without use of the hinge method. It looks good and will protect most of the screen, but this isn't good enough for a tool that is supposed to protect the device's full display. A chip and crack in the unprotected area may end up spreading damage across the remainder of the screen.

I have put these on all the GPS units for our search team, good stuff.

Easy to set up economy priced with a clear screen

Should have read the reviews....I looked at the overall high star rating and have enjoyed this brand on other devices so I didn't pay attention. The 65s has a bevel on the side. That this protector doesn't cover the bevel isn't a problem for me, and the fact it's a little short top to bottom is something I can live with. The problem is that side to side, it is a little bigger than the flat area of the 65s screen. it's only a little overhang, but it's there and in one day already collecting dirt. The silicone case I got (bright orange so I can easily see device) doesn't overlap the screen to hide/protect the overhand from accumulating dirt and eventually likely allowing dirt under the protector and/or catching something and popping off. My bad for not reading the good warnings by others.